Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: michaelb63
Showing results 1 to 25 of 49
Search took 0.00 seconds.
Forum: Do It Yourself, Boating on a Budget
05-19-2015, 09:25 AM
Replies: 14
Views: 7,209
Posted By michaelb63

Jet Boat wind deflector www.bpmdesigns.co.nz/ ...

Jet Boat wind deflector
www.bpmdesigns.co.nz/
a little pricey,i just mounted spring clamps to to the plexiglass to clamp to my wind screen
Forum: Swap Shop
03-15-2015, 07:23 PM
Replies: 22
Views: 8,009
Posted By michaelb63

are the s/m salt or fresh water,

are the s/m salt or fresh water,
Forum: General Q & A
06-17-2013, 07:28 PM
Replies: 46
Views: 4,876
Posted By michaelb63

that actually looks pretty good.make sure theirs...

that actually looks pretty good.make sure theirs not any of the old impeller blocking your coolers
Forum: Do It Yourself, Boating on a Budget
10-02-2012, 04:49 PM
Replies: 29
Views: 3,674
Posted By michaelb63

does the same thing with a 13.750x23 3 blade the...

does the same thing with a 13.750x23 3 blade the 350 mag would spin it at 5200 rpm . but seeing that boat season is pretty much done here .going to go ahead and pull the motor out and reuild it...
Forum: Do It Yourself, Boating on a Budget
09-24-2012, 05:22 PM
Replies: 29
Views: 3,674
Posted By michaelb63

pulls strong up to 4000 just hits a wall,no no...

pulls strong up to 4000 just hits a wall,no no breaking up or,misfires thunderbolt IV ignition 8 psi fuel pressure at idel to wot.
Forum: Do It Yourself, Boating on a Budget
09-24-2012, 05:21 PM
Replies: 29
Views: 3,674
Posted By michaelb63

pulls strongup to 4000 just hits a wall,no no...

pulls strongup to 4000 just hits a wall,no no breaking up or,misfires
Forum: Do It Yourself, Boating on a Budget
09-24-2012, 05:17 PM
Replies: 29
Views: 3,674
Posted By michaelb63

plugs gaped at. 035

plugs gaped at. 035
Forum: Do It Yourself, Boating on a Budget
09-24-2012, 05:16 PM
Replies: 29
Views: 3,674
Posted By michaelb63

thunderbolt IV ignition plugs gaped at 035

thunderbolt IV ignition plugs gaped at 035
Forum: Do It Yourself, Boating on a Budget
09-20-2012, 04:32 PM
Replies: 29
Views: 3,674
Posted By michaelb63

thanks griff ill give that a try this weekend and...

thanks griff ill give that a try this weekend and see what happens
Forum: Do It Yourself, Boating on a Budget
09-20-2012, 06:32 AM
Replies: 29
Views: 3,674
Posted By michaelb63

15dia 22 pitch 4 blade /1:50 but it will do the...

15dia 22 pitch 4 blade /1:50 but it will do the same with a 13.750 23 3 blade.
Forum: Do It Yourself, Boating on a Budget
09-20-2012, 06:28 AM
Replies: 29
Views: 3,674
Posted By michaelb63

no detonation,pops or backfires starts great...

no detonation,pops or backfires starts great ,idels great,runs great, just wont go past 4000
Forum: Do It Yourself, Boating on a Budget
09-20-2012, 06:23 AM
Replies: 29
Views: 3,674
Posted By michaelb63

plugs are a nice tan color,look goood

plugs are a nice tan color,look goood
Forum: Do It Yourself, Boating on a Budget
09-20-2012, 06:22 AM
Replies: 29
Views: 3,674
Posted By michaelb63

bought engine as is runs extremly rich with 90...

bought engine as is runs extremly rich with 90 in secondary,5 psi boost,cant find any info on cam. probly pull it out and go with a lt4 hot cam.
Forum: Do It Yourself, Boating on a Budget
09-19-2012, 06:42 PM
Replies: 29
Views: 3,674
Posted By michaelb63

blown 350 wont pull over 4000rpm

ok heres the parts list.2010 block 030 over 4 bolt main ,9.5:1hyperuetectic pistons,world products sportsman 2 heads 72 cc ,es1095m cam450/461 lift 224/224dur, 1.6 alum full rollerrocker,hi...
Forum: Do It Yourself, Boating on a Budget
07-31-2012, 08:47 PM
Replies: 8
Views: 5,458
Posted By michaelb63

yes there should be an o ring seal ,and a lot of...

yes there should be an o ring seal ,and a lot of silicone just to be safe
Forum: Do It Yourself, Boating on a Budget
07-30-2012, 08:06 PM
Replies: 13
Views: 2,383
Posted By michaelb63

think i found the problem pulled conection to ...

think i found the problem pulled conection to modular off pulled rubber boot off ,the ground wire connector was pushed all the way off to one side.no way it was makeing a solid connection ,...
Forum: Do It Yourself, Boating on a Budget
07-29-2012, 09:47 PM
Replies: 13
Views: 2,383
Posted By michaelb63

base timming set at 19* so all in would be at...

base timming set at 19* so all in would be at about 29* should be right in the ballpark, but dosent seem like the timming is advanceing after 2500 rps like it should
Forum: Do It Yourself, Boating on a Budget
07-29-2012, 09:39 PM
Replies: 13
Views: 2,383
Posted By michaelb63

used b&m142 5lbs boost on gauge

used b&m142 5lbs boost on gauge
Forum: Do It Yourself, Boating on a Budget
07-29-2012, 06:11 PM
Replies: 13
Views: 2,383
Posted By michaelb63

fuel system up graded high volume pump and 1/2...

fuel system up graded high volume pump and 1/2 hose id, no pops or bangs just wont run over 3000 rpm,??????
Forum: Do It Yourself, Boating on a Budget
07-29-2012, 01:32 PM
Replies: 13
Views: 2,383
Posted By michaelb63

thunderbolt iv ignition modual

any way to test a v6 14 ignnition modual,swaped out the v8 22 for more base timming put a blower on sbc wont go over 3000 rpm :poopoo:
Forum: General Q & A
07-11-2012, 09:33 PM
Replies: 25
Views: 8,929
Posted By michaelb63

+1 works great just pulled mine,and dropped in a...

+1 works great just pulled mine,and dropped in a new one.
Forum: Do It Yourself, Boating on a Budget
07-07-2012, 07:32 AM
Replies: 13
Views: 4,165
Posted By michaelb63

mine was stuck on full,replace your sending...

mine was stuck on full,replace your sending unit.got mine online with overtons, 40.00 bucks its nice to know how much gas you have in the tank
Forum: Do It Yourself, Boating on a Budget
07-05-2012, 04:10 PM
Replies: 2
Views: 683
Posted By michaelb63

b&m 142

no it turned freely by hand when it was on the motor,it backfired now it has a slight tight spot. read somewhere on here a backfire could nock it out of time .???
Forum: Do It Yourself, Boating on a Budget
07-03-2012, 09:13 PM
Replies: 2
Views: 632
Posted By michaelb63

sounds like you have some blockage some where....

sounds like you have some blockage some where. can you swap your hose from side to side to see if it does the same,
Forum: Do It Yourself, Boating on a Budget
07-03-2012, 08:49 PM
Replies: 2
Views: 683
Posted By michaelb63

b&m 142

just bought a used b&m 142 ,it turned freely by hand ,put it on motor,tried to start it motor backfired, now it has a slight tight spot when turning by hand,anyone know if the smaller blowers need...
Showing results 1 to 25 of 49
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.