Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: woody81
Showing results 1 to 17 of 17
Search took 0.00 seconds.
03-12-2020, 08:32 PM
Replies: 605
Views: 123,598
Posted By woody81

oil. Buying DNR and BTE.

oil. Buying DNR and BTE.
Forum: Formula
03-01-2020, 08:19 PM
Replies: 17
Views: 6,849
Posted By woody81

my boat is stored inside a climate controlled...

my boat is stored inside a climate controlled garage. SeaDek is only a year old. So far so good. No complaints. For some reason they roll up the mats for shipping. That causes the rolling up on...
Forum: General Q & A
08-20-2019, 08:24 PM
Replies: 24
Views: 4,922
Posted By woody81

im guessing it’s a fuel pressure problem. My...

im guessing it’s a fuel pressure problem. My friend replaced his high pressure fuel pump and that fixed his problem.
Forum: General Q & A
08-13-2019, 09:09 PM
Replies: 12
Views: 1,317
Posted By woody81

. The engine oil cooler is the first to plug up...

. The engine oil cooler is the first to plug up and cause blockage. It is located at the rear, up high on the engine. Working from the front of the engine, it’s only one center bolt to remove the...
05-06-2019, 08:34 PM
Replies: 32
Views: 9,021
Posted By woody81

I just set up my 38zx donzi with a Honda 2200. ...

I just set up my 38zx donzi with a Honda 2200. Runs great with 2 generators paired together. 1 Honda 2200 will run my A/C, refrigerator, and Battery charger, but it’s running wide open. They will...
Forum: Baja
12-04-2018, 08:24 PM
Replies: 6
Views: 2,632
Posted By woody81

My last Baja was a 1989 sport 250. It has 2 blue...

My last Baja was a 1989 sport 250. It has 2 blue hockey stick style stripes down the side. Maybe it is a few years older than he thinks.
Forum: General Q & A
05-10-2018, 08:49 PM
Replies: 8
Views: 2,120
Posted By woody81

The engine oil cooler is the first to clog. It’s...

The engine oil cooler is the first to clog. It’s located at the rear of the engine, up high. It’s very hard to see so look closely. It looks like the cooler at the front of the engine, only...
04-12-2018, 08:22 PM
Replies: 9
Views: 1,597
Posted By woody81

Yolk shaft seal tore on my bravo 1 and leaked oil...

Yolk shaft seal tore on my bravo 1 and leaked oil into the bilge. My seal went out on a busy weekend. Its strange yours is leaking just coming out of storage.
10-19-2016, 08:27 PM
Replies: 20
Views: 5,006
Posted By woody81

My 525's were unopened until 480 hours. A leak...

My 525's were unopened until 480 hours. A leak down test showed head gaskets were going bad between cyclinders 4&6. My engines are year 2003. New gaskets, valve job, and springs, cost about $3,000...
Forum: General Q & A
08-29-2016, 08:10 PM
Replies: 12
Views: 1,369
Posted By woody81

My 525efi had a plugged heat exchanger...

My 525efi had a plugged heat exchanger restricting the water flow. I cleaned The oil cooler at the back of the engine and now it's much better water flow.
Forum: General Q & A
06-18-2016, 06:02 PM
Replies: 14
Views: 2,030
Posted By woody81

My header overheating issues were caused by a...

My header overheating issues were caused by a clogged heat exchanger. The engine oil cooler was plugged. Looking at the front of the engine, the cooler is on the back side. Its tucked in tight...
03-04-2016, 08:59 PM
Replies: 45
Views: 9,262
Posted By woody81

I've got a 2003 Donzi 38ZX. 525efi. 500 hours. ...

I've got a 2003 Donzi 38ZX. 525efi. 500 hours. Bone stock, never opened until this winter. Leak down test showed bad head gasket between 4&6. Compression was about 120 psi. Fresh top end with...
08-19-2014, 09:06 PM
Replies: 25
Views: 3,905
Posted By woody81

The lake wasn't too bad in the morning heading...

The lake wasn't too bad in the morning heading from Indiana to Chicago. The forecast called for 2-4 footers all day. Going from Chicago to Indiana about 4 o'clock got really bad. The waves were...
03-18-2014, 07:44 PM
Replies: 70
Views: 6,360
Posted By woody81

2011 f-450 6.7 PSD with 4:30 gear. 12 MPG empty....

2011 f-450 6.7 PSD with 4:30 gear. 12 MPG empty. About 7 or 8 MPG towing. Mpg doesn't change much if I'm towing an empty 29' enclosed trailer or if I'm towing the 38' donzi ZX. I usually run 72 mph....
Forum: Swap Shop
01-13-2014, 08:39 PM
Replies: 3
Views: 442
Posted By woody81

Just use a chop saw or a partner saw with a fiber...

Just use a chop saw or a partner saw with a fiber blade and cut it down to where you want it.
12-27-2013, 08:12 PM
Replies: 265
Views: 132,646
Posted By woody81

I've got 440 hours on both of my '03 525's. The...

I've got 440 hours on both of my '03 525's. The previous owner said they have never had any problems. They are stock and still run strong. It sure is scary reading all this. I definitely need to...
Forum: Donzi
07-01-2013, 07:09 PM
Replies: 22
Views: 5,137
Posted By woody81

Love the Donzi! Yes, it needs to be about 4...

Love the Donzi! Yes, it needs to be about 4 feet further forward on the trailer
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.