Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: chartersj
Showing results 1 to 25 of 65
Search took 0.00 seconds.
09-24-2022, 05:16 PM
Replies: 2
Views: 960
Posted By chartersj

ok thanks will do if I can save the rest of it

ok thanks will do if I can save the rest of it
09-24-2022, 11:32 AM
Replies: 2
Views: 960
Posted By chartersj

Bravo trim sender delete

I’m starting the process of changing my steering swivel pin and start out by breaking the screws off for the sending units. I’m sure I could drill and tap them out but my boat has mechanical...
Forum: Prop Talk
08-09-2021, 06:07 PM
Replies: 3
Views: 1,332
Posted By chartersj

Yeah sounds good. Just looking around at similar...

Yeah sounds good. Just looking around at similar set ups to mine 60 seems to be on the low side. Was thinking about trying a mirage 23plus to see what that does
Forum: Scarab
08-05-2021, 07:24 AM
Replies: 3
Views: 1,768
Posted By chartersj

Yep same person

Yep same person
Forum: Scarab
08-05-2021, 05:43 AM
Replies: 3
Views: 1,768
Posted By chartersj

I inquired about the side vents a couple years...

I inquired about the side vents a couple years ago and if it’s the same guy the moulds had been lost in a fire unfortunately
Forum: Prop Talk
08-03-2021, 07:02 AM
Replies: 3
Views: 1,332
Posted By chartersj

496ho prop

I have a 1996 scarab 26 with a 496Ho running a bravo 1 24 pitch prop. I recently hooked up vessel view to it and while the dash rpm gauge is reading 4800-5000rpm wide open vessel view is showing 4660...
Forum: General Q & A
06-07-2020, 07:21 AM
Replies: 24
Views: 7,313
Posted By chartersj

Is there internal baffles or flappers with that...

Is there internal baffles or flappers with that exhaust? Is the exhaust all tight all the way to the tips and no leaks?
Forum: Swap Shop
11-13-2019, 07:43 PM
Replies: 51
Views: 14,191
Posted By chartersj

What shape are the 496 raw water pumps in?

What shape are the 496 raw water pumps in?
Forum: Wanted
09-19-2019, 06:37 AM
Replies: 4
Views: 611
Posted By chartersj

Yeah I have read that's the best option. My pump...

Yeah I have read that's the best option. My pump has scoring in the brass so I already have the ss washers on either side of the impeller
Forum: Wanted
09-19-2019, 06:31 AM
Replies: 4
Views: 611
Posted By chartersj

Yeah that's a good idea. And that way I could...

Yeah that's a good idea. And that way I could have a spare as well if I do find another
Forum: Wanted
09-18-2019, 07:25 AM
Replies: 4
Views: 611
Posted By chartersj

496 raw water pump

ISO 496ho raw water pump, mine is leaking from the seal behind pulley, thought I would look here before I go new
07-31-2019, 10:17 AM
Replies: 15
Views: 4,019
Posted By chartersj

Bravoitis?

Bravoitis?
Forum: General Q & A
06-16-2019, 06:55 PM
Replies: 7
Views: 1,082
Posted By chartersj

The help and information you offer over the phone...

The help and information you offer over the phone and on this website is very appreciated. If I do end up having problems with the pcm down the road you can be sure I will be sending it your way.
Forum: General Q & A
06-16-2019, 03:39 PM
Replies: 7
Views: 1,082
Posted By chartersj

Turns out it was my smart craft harness. I...

Turns out it was my smart craft harness. I unplugged it when I pulled the motor last fall and set it on the bench . Its one plug on the top of the motor that branches off to a few smaller ones if you...
Forum: General Q & A
06-16-2019, 04:47 AM
Replies: 7
Views: 1,082
Posted By chartersj

Thank you for listening to my issue I know your...

Thank you for listening to my issue I know your time is valuable. But the fuse was not my issue because it doesn't have one. I will be ordering one tomorrow for it. I will mention i found 5 volts on...
Forum: General Q & A
06-13-2019, 07:27 PM
Replies: 7
Views: 1,082
Posted By chartersj

Battery was at 12.7 when i put the motor in but...

Battery was at 12.7 when i put the motor in but is at 12.4 volts right now from working on lights and stereo. I get the 12.4 to the relay from the key.
Forum: General Q & A
06-13-2019, 07:16 PM
Replies: 7
Views: 1,082
Posted By chartersj

496 no start electrical issue

I cannot get my 2007 496 to start. The starter relay will not operate with the key. It will roll over if i cross the relay. I swapped relays and it does the same thing. I get 12 volts on the...
Forum: General Q & A
06-12-2019, 06:29 AM
Replies: 0
Views: 436
Posted By chartersj

Looking for a wiring diagram for 14 pin 496ho

Does anyone have or know where I can get a copy of a wiring diagram for a 2007 496 ho with 14 pin harness? My manual doesn't have one and can only find diagrams online that have the 10 pin harness.
Forum: Wanted
05-15-2019, 06:00 AM
Replies: 5
Views: 723
Posted By chartersj

Looking for one with both sides right now but...

Looking for one with both sides right now but will keep you in mind, Thanks
Forum: Wanted
05-14-2019, 07:54 AM
Replies: 5
Views: 723
Posted By chartersj

WTB bravo drive shower

Looking for a Simrek drive shower or similar design
Forum: General Q & A
04-30-2019, 11:54 AM
Replies: 3
Views: 544
Posted By chartersj

I traced the tan/blue from the male side of the...

I traced the tan/blue from the male side of the cannon plug and it goes to the pcm as you said. It sounds more like a bad/loose connection then something wrong with the pcm? I verified the horn works...
Forum: General Q & A
04-26-2019, 01:39 PM
Replies: 3
Views: 544
Posted By chartersj

496 key on beep

Last summer the single beep when I turn the key to the on position was random if it worked or not. It would always start up fine and did not have beeps while running. I put 12+ directly to the horn...
04-26-2019, 11:59 AM
Replies: 0
Views: 366
Posted By chartersj

496 key on beep

Last summer the single beep when I turn the key to the on position was random if it worked or not. It would always start up fine and did not have beeps while running. I put 12+ directly to the horn...
03-04-2019, 08:14 AM
Replies: 33
Views: 17,559
Posted By chartersj

Still have these?

Still have these?
10-23-2018, 08:35 AM
Replies: 27
Views: 3,111
Posted By chartersj

I'm on Grand Manan island. I have never been that...

I'm on Grand Manan island. I have never been that far up the bay but I can cross to either side no problem from where I am at. The bay does get rough with all the current but I just moved up to what...
Showing results 1 to 25 of 65
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.