Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: warlocky
Showing results 1 to 17 of 17
Search took 0.00 seconds.
Forum: General Q & A
08-29-2018, 03:22 PM
Replies: 44
Views: 9,481
Posted By warlocky

pick ups are on the side of the lower unit...

pick ups are on the side of the lower unit only.no thermostate spacer and i believe it is installed right.spring is toward the botton of intake.boat dose 80 mph at wot.
Forum: General Q & A
08-29-2018, 03:19 PM
Replies: 44
Views: 9,481
Posted By warlocky

3/4 i think.thats the size of the outlet

3/4 i think.thats the size of the outlet
Forum: General Q & A
08-28-2018, 04:10 PM
Replies: 44
Views: 9,481
Posted By warlocky

mid to wot

mid to wot
Forum: General Q & A
08-28-2018, 03:17 PM
Replies: 44
Views: 9,481
Posted By warlocky

no.The only restriction i can think of is the s...

no.The only restriction i can think of is the s pipe is to close to the end of the riser causeing a back up kinda.everything is clear.i think i saw some deals you block off some of the holes on a...
Forum: General Q & A
08-28-2018, 12:55 PM
Replies: 44
Views: 9,481
Posted By warlocky

0 to 35

0 to 35
Forum: General Q & A
08-28-2018, 12:43 PM
Replies: 44
Views: 9,481
Posted By warlocky

only exit i have are the exhaust and one dump...

only exit i have are the exhaust and one dump with the relief value
Forum: General Q & A
08-28-2018, 12:28 PM
Replies: 44
Views: 9,481
Posted By warlocky

yes.thats where i get the most water

yes.thats where i get the most water
Forum: General Q & A
08-28-2018, 11:57 AM
Replies: 44
Views: 9,481
Posted By warlocky

https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1124/water_presure_002_5b3ecc64b3576f98a53f57609ef0744e3201a4ef.jpg...
Forum: General Q & A
08-28-2018, 11:51 AM
Replies: 44
Views: 9,481
Posted By warlocky

It wont let me post photos.

It wont let me post photos.
Forum: General Q & A
08-28-2018, 10:43 AM
Replies: 44
Views: 9,481
Posted By warlocky

I added a presure value to the intale line after...

I added a presure value to the intale line after my cooler.the hose was allready cut there.......got it set to the lowest possible rate.check all lines,exhoust risers are clean.move my presure line...
Forum: General Q & A
07-25-2018, 09:11 AM
Replies: 44
Views: 9,481
Posted By warlocky

all stock stuff.side mounted water pump,running...

all stock stuff.side mounted water pump,running stock circulating pump.going to check my exhoust.pull the risers and see if there are stoped up.i have my water presure line in the block wher the side...
Forum: General Q & A
07-24-2018, 07:08 PM
Replies: 44
Views: 9,481
Posted By warlocky

My pick up is on the drive.dravo 1 standard unit

My pick up is on the drive.dravo 1 standard unit
Forum: General Q & A
07-24-2018, 02:08 PM
Replies: 44
Views: 9,481
Posted By warlocky

I need to check this out.

I need to check this out.
Forum: General Q & A
07-24-2018, 08:59 AM
Replies: 44
Views: 9,481
Posted By warlocky

Thats what i did.I dont get enough water to the...

Thats what i did.I dont get enough water to the thermostat to build any heat and it will run hot.my temp guage wont move even though its hot.no water to front of intake.
Forum: General Q & A
07-24-2018, 08:56 AM
Replies: 44
Views: 9,481
Posted By warlocky

Its allways had high presure.WOT is 30 plus.i may...

Its allways had high presure.WOT is 30 plus.i may have some restrictions.not sure.Just been building the boat the last 2 years.the 2 dumps i added to the rear of the intake worked but i dont get...
Forum: General Q & A
07-23-2018, 04:01 PM
Replies: 44
Views: 9,481
Posted By warlocky

Wher did you get them and where do you install...

Wher did you get them and where do you install them at.
Forum: General Q & A
07-23-2018, 09:16 AM
Replies: 44
Views: 9,481
Posted By warlocky

Water dumps

I have a warlock 25 sxt with a carb 502.i have to much water presure.I put 2 dumps off the rear of the intake with values to controll the flow but the motor dosnt get enough water to the...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.