Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Tom Earhart
Showing results 1 to 25 of 80
Search took 0.01 seconds.
Forum: Eliminator
10-19-2011, 07:29 AM
Replies: 3
Views: 1,344
Posted By Tom Earhart

Pulled both motors last weekend. I am going to...

Pulled both motors last weekend. I am going to have to take the starboard motor apart, as it has lost compression on one of the cylinders. I'll make the repairs and dyno both motors. The water in the...
Forum: Eliminator
10-10-2011, 08:41 PM
Replies: 3
Views: 1,344
Posted By Tom Earhart

Water in fuel

I have had to drain my tanks twice,has anybody else had a problem with water in their fuel? I am starting to suspect the gas tank vents. I store it outside so it gets rained on. 2007 28' Daytona....
Forum: Eliminator
10-04-2011, 07:28 AM
Replies: 2
Views: 1,524
Posted By Tom Earhart

28' Daytona Lighter Motors?

Has anyone tried lighter engines in a 28' Eliminator? I have developed an engine package for my 19' Eliminator that has 600 HP @ 6000 RPM and 595 Ft/lbs @ 4500. Torque begins at 2800 RPM with 530...
Forum: Eliminator
09-30-2011, 07:59 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

Has anyone tried putting a lighter motors in the...

Has anyone tried putting a lighter motors in the 28'? I have developed a 3.8 for my 19' eliminator that has big torque numbers and 600 HP at 6000 RPM on pump gas. A pair would probably take 750 lbs....
Forum: Eliminator
09-15-2011, 09:08 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

I took the boat out tonight to see if I could...

I took the boat out tonight to see if I could stretch out those 34 herrings. Perfect conditions small chop, 60 degrees, and not much traffic. 104 mph GPS, 4750 rpm, 1.35 gear ratio = 8% slip. I...
Forum: Eliminator
09-14-2011, 03:31 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

rbtnt: What was the horsepower of your 540's?

rbtnt: What was the horsepower of your 540's?
Forum: Eliminator
09-14-2011, 08:56 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

GPM What is your shaft height to bottom of boat?

GPM What is your shaft height to bottom of boat?
Forum: Eliminator
09-13-2011, 09:24 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

GPM Stock Mercury with shaft center line 1.5...

GPM Stock Mercury with shaft center line 1.5 above bottom of boat.
Forum: Eliminator
09-12-2011, 12:40 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

I tried the 34's gained 4 mph. They are harder to...

I tried the 34's gained 4 mph. They are harder to get on plane, the acceleration seems to be about the same. I never used the trim tab before to get on plane, but I'll be trying different settings to...
Forum: Eliminator
09-09-2011, 10:24 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

I am going to try a set of 34" pitch herrings...

I am going to try a set of 34" pitch herrings this weekend, probably knock her right to her knees.
Forum: Eliminator
08-30-2011, 07:18 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

rbtnt: Thanks for the come back I was just ready...

rbtnt: Thanks for the come back I was just ready to pull the trigger on a couple sets of 1.26 gears. What kind of speed did you get with the 34" props? Have you modified your engines, if so what did...
Forum: Eliminator
08-29-2011, 03:50 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

Has anyone tried the 1:26 gear ratio with 30...

Has anyone tried the 1:26 gear ratio with 30 pitch props on a 28 Daytona?
Forum: Eliminator
08-25-2011, 08:40 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

My prop shafts are 1.5" above the bottom of the...

My prop shafts are 1.5" above the bottom of the boat and I don't have any transome extensions.
Forum: Eliminator
08-24-2011, 04:00 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

Adrenaline Junkie how much trim did you run? My...

Adrenaline Junkie how much trim did you run? My drives are stamped 1:35 ratio, they also have a big prop shaft. You mentioned that your drives were 1:36. I know that my prop shafts are above the...
Forum: Eliminator
08-24-2011, 07:28 AM
Replies: 25
Views: 7,915
Posted By Tom Earhart

WETTE VETTE Yes I will be at Hardy, I am still...

WETTE VETTE Yes I will be at Hardy, I am still learning how to drive the boat, I am not sure how much trim to run, it seems to want very little.
Tom
Forum: Eliminator
08-23-2011, 12:12 PM
Replies: 25
Views: 7,915
Posted By Tom Earhart

28 Eliminator stock what's the best setup

I have just purchased a 28 Eliminator with twin 496's, 30 pitch lab 5 blades, & a 1.35 gear ratio. I was wondering what the best setup is for this boat. Should I change the gear ratio or the prop...
Forum: General Boating Discussion
09-30-2010, 01:37 PM
Replies: 251
Views: 58,350
Posted By Tom Earhart

Throttle Fever

I think your torque would be 15756 Ft/Lb's @ 2000 rpm
Tom
Forum: Apache
08-14-2008, 01:13 PM
Replies: 122
Views: 31,863
Posted By Tom Earhart

mrhorsepower1

Could you post a dyno sheet on your 1700 hp engine?
Thanks, Tom
Forum: Apache
08-06-2008, 02:17 PM
Replies: 122
Views: 31,863
Posted By Tom Earhart

Allez Vite 3000 HP

So Apache Pete how fast do you think she would " allez vite " go?
Tom Earhart
Forum: General Boating Discussion
10-05-2006, 08:30 PM
Replies: 10
Views: 1,807
Posted By Tom Earhart

Re: Alumn Creek

Where is the launch site at Brookville?
Forum: General Boating Discussion
10-05-2006, 05:32 PM
Replies: 10
Views: 1,807
Posted By Tom Earhart

Re: Alumn Creek

Where is Brookville at?
Tom
Forum: General Boating Discussion
10-04-2006, 09:40 PM
Replies: 10
Views: 1,807
Posted By Tom Earhart

Alumn Creek

Is there going to be a shoot out at Alumn Creek this year?
Forum: General Boating Discussion
02-02-2006, 05:11 AM
Replies: 26
Views: 13,359
Posted By Tom Earhart

Re: Lake Norman NC

Swede, beautiful boat what do you have for power, how long is it? Do you live on lake Norman? I am thinking of moving down there.
Thanks, Tom
Forum: General Boating Discussion
01-25-2006, 05:16 AM
Replies: 26
Views: 13,359
Posted By Tom Earhart

Re: Lake Norman NC

Mark, I have a 24 Eliminator with a twin turbo 572" chevy, B-Max drive, and Herring prop. It accelerates hard to about 130 mph
Thanks, Tom
Forum: General Boating Discussion
01-24-2006, 08:46 PM
Replies: 26
Views: 13,359
Posted By Tom Earhart

Lake Norman NC

Does anyone know if they have a speed limit on Lake Norman? A bunch of guys that I boat with thought it would be fun to go down there on Mother's Day when the NASCAR guys have time off and see if we...
Showing results 1 to 25 of 80
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.