Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: cloudmaster_321
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Drives and Lower Units
07-09-2025, 09:25 PM
Replies: 4
Views: 959
Posted By cloudmaster_321

I probably will run it. Likely about 10-15 hrs...

I probably will run it. Likely about 10-15 hrs this year. Just dumb that the yoke is rubbing the seal. Looking at my log, this is 25 hrs after a new upper gear set.

just checked for end play. I...
Forum: Drives and Lower Units
07-09-2025, 08:22 PM
Replies: 4
Views: 959
Posted By cloudmaster_321

Found drive lube in bellows

Pulled my bravo one off for some regular maintenance, greasing u joints, etc. found a 1/4 cup or so of drive lube in the bellows. I can only assume it’s from the input seal. Took a look at that,...
Forum: General Q & A
05-19-2025, 12:40 PM
Replies: 2
Views: 753
Posted By cloudmaster_321

Honestly, this is the first time i've checked...

Honestly, this is the first time i've checked this boat since owning it for 3 years. So i have no frame of reference in the past for alignment. Will going forward though......
Forum: General Q & A
05-19-2025, 09:21 AM
Replies: 2
Views: 753
Posted By cloudmaster_321

Twin I/O's engine alignment question

Completing annual maintenance on my twin. Alignment on the port motor was off a smidge. Alignment bar went in with some force, and didn't bottom nice. Grease indication was on the bottom. Ended...
Forum: Drives and Lower Units
09-03-2024, 02:42 PM
Replies: 9
Views: 1,356
Posted By cloudmaster_321

Update on this: First off, as previously...

Update on this:

First off, as previously stated, i installed a new cap. That did not fix the issue.

I ordered and installed a new Quick Silver reservoir and cap assembly. The new bottle has...
Forum: Drives and Lower Units
08-14-2024, 12:52 PM
Replies: 9
Views: 1,356
Posted By cloudmaster_321

I have the Simrek drive showers installed on each...

I have the Simrek drive showers installed on each drive
Forum: Drives and Lower Units
08-14-2024, 12:50 PM
Replies: 9
Views: 1,356
Posted By cloudmaster_321

I have about 3.5-4 hrs on it this summer only.

I have about 3.5-4 hrs on it this summer only.
Forum: Drives and Lower Units
08-14-2024, 12:47 PM
Replies: 9
Views: 1,356
Posted By cloudmaster_321

I water was getting in, I would assume the oil...

I water was getting in, I would assume the oil level would not go down to the normal level on the res. I'd assume it would stay high.........
Forum: Drives and Lower Units
08-12-2024, 12:46 PM
Replies: 9
Views: 1,356
Posted By cloudmaster_321

Bravo 3 overflowing the drive reservoir

I have twin bravo 3's on my sundancer 310. My starboard side is overflowing the reservoir when under way. I opened the hatch after a 5 mile run and it was up to the cap. When it cools off it drops to...
Forum: Great Lakes and Canada
05-14-2024, 01:03 PM
Replies: 16
Views: 4,027
Posted By cloudmaster_321

Howdy all, just happen to run across this thread....

Howdy all, just happen to run across this thread.

As a resident of Sun Prairie, i'm 15 mins from being able to drop the boat in the Madison lakes. I mostly run Mendota. Yes, if you run open...
Forum: Drives and Lower Units
05-14-2024, 12:49 PM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

i agree. It's the same thing i would have done...

i agree. It's the same thing i would have done if i hadn't read that in the book.

-Ryan
Forum: Drives and Lower Units
05-13-2024, 07:57 PM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

Oring glue

The manual references bellows adhesive for the rear cover orings? Really? I was going to use 2-4-c, or perfect seal. But I’d have to get the bellows glue. What do you all use?
Forum: Drives and Lower Units
05-09-2024, 04:04 PM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

Copy that, I'll take a look. One other thing...

Copy that, I'll take a look.

One other thing to note, i installed the Simrek drive shower, and it bolts to the upper left using the cover bolt. I'm wondering if overtightening that could have...
Forum: Drives and Lower Units
05-08-2024, 08:57 AM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

I reinstalled the drive last year. I don't...

I reinstalled the drive last year. I don't remember. I believe i did, but not sure. I usually just use 2-4-c grease on the orings to aid in sealing. I can replace the orings this season just to be...
Forum: Drives and Lower Units
05-08-2024, 06:52 AM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

not sure. I did t do the work last year. I...

not sure. I did t do the work last year. I hired it out. How do I tell other than pulling the nut off?
Forum: Drives and Lower Units
05-07-2024, 09:04 PM
Replies: 10
Views: 1,615
Posted By cloudmaster_321

Water in shift pocket of bravo 3

Hey all. I pulled my drive for annual maintenance and noticed water sitting in the shift pocket . The orange oring was intact, and the shifter bellows was replaced last season. I don’t see any...
Forum: Do It Yourself, Boating on a Budget
07-25-2023, 06:29 AM
Replies: 7
Views: 1,410
Posted By cloudmaster_321

R5673-7 v-power 7 is what is in there

R5673-7 v-power 7 is what is in there
Forum: Do It Yourself, Boating on a Budget
07-24-2023, 07:58 PM
Replies: 7
Views: 1,410
Posted By cloudmaster_321

It was just interesting to me that the engine...

It was just interesting to me that the engine builder decided to go with a colder plug than stock. The delcos are a bit hotter.
Forum: Do It Yourself, Boating on a Budget
07-24-2023, 06:49 AM
Replies: 7
Views: 1,410
Posted By cloudmaster_321

Spark plugs

no issues necessarily. Just wanted to change them out. They have been in there for a couple hundred hours. ...
Forum: Do It Yourself, Boating on a Budget
07-23-2023, 09:56 PM
Replies: 7
Views: 1,410
Posted By cloudmaster_321

Merc 502 MPI spark plugs

Pulled spark plugs for an inspection. Lightly modded 502mpi putting out 460hp. Had NGKV Power 7 in it. Stock is AC Delco MR43T

what’s the recommendations?
Forum: General Q & A
06-28-2023, 12:16 PM
Replies: 0
Views: 571
Posted By cloudmaster_321

Mercury SB 03-05

Can anyone tell me what this is, or what the parts are?

Pertains to the 6.2L MX.

Thanks.
Forum: General Q & A
06-21-2023, 11:27 AM
Replies: 7
Views: 2,944
Posted By cloudmaster_321

Anyone have a cooling diagram for a '95 502MPI?

Looking for a cooling diagram for a '95 502MPI. My stbrd exhuast is getting hotter than the port. Little bit of steam coming out after a hard run until the system cools back off. Port side has a...
Forum: Drives and Lower Units
06-20-2023, 02:06 PM
Replies: 11
Views: 1,550
Posted By cloudmaster_321

mine is a 2.20 ratio

mine is a 2.20 ratio
Forum: Drives and Lower Units
06-20-2023, 01:04 PM
Replies: 0
Views: 769
Posted By cloudmaster_321

1.50 gear set needed

Since my buddy George @ ADDS put in 1.65 gears vs 1.50's; my rpms are wrong. Put my bigger prop on, and still rpm's are wrong. So i've got about 10 hrs on a 1.65 gear set. Looking to see if...
Forum: Drives and Lower Units
06-20-2023, 01:01 PM
Replies: 11
Views: 1,550
Posted By cloudmaster_321

My drive is from 2001. Single anode though.

My drive is from 2001. Single anode though.
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.