Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: GSS0816
Showing results 1 to 23 of 23
Search took 0.03 seconds.
Forum: General Boating Discussion
08-28-2007, 09:27 AM
Replies: 21
Views: 2,599
Posted By GSS0816

What happened to the guys in the boat that got...

What happened to the guys in the boat that got run over...looks like one of them was missing. That is some scary stuff there.
Forum: General Q & A
08-27-2007, 09:36 PM
Replies: 8
Views: 5,130
Posted By GSS0816

Yes as long as the 454 is a one piece rear main...

Yes as long as the 454 is a one piece rear main seal like the 502, should work.
Forum: Drives and Lower Units
08-12-2007, 07:33 AM
Replies: 6
Views: 1,325
Posted By GSS0816

Bravo question

Is it possible to close the low water pick up on the Bravo 1. I have both low and middle pick up on the bravo, and get tired of sucking up mud sand through the low pick up.If so any suggestions on...
Forum: General Q & A
08-10-2007, 08:22 AM
Replies: 6
Views: 994
Posted By GSS0816

Does it do this while under power, and when it...

Does it do this while under power, and when it happens does it feel like he hit something? Sounds like it may be a clutch dog.
Steve
Forum: General Q & A
07-25-2007, 02:11 PM
Replies: 5
Views: 1,957
Posted By GSS0816

Thanks, That's what I thought. Steve

Thanks, That's what I thought.
Steve
Forum: General Q & A
07-25-2007, 11:03 AM
Replies: 5
Views: 1,957
Posted By GSS0816

Ok, I bet that is what it was for, looks to be in...

Ok, I bet that is what it was for, looks to be in the right place. If I chose to run a PVC, would I run it in the valve cover, like the cars do. What about the other valve cover opening, put a...
Forum: General Q & A
07-25-2007, 10:13 AM
Replies: 5
Views: 1,957
Posted By GSS0816

Early 502 EFI question.

I bought an EFI set up from a guy, it is the style that uses the fuel pump on the block. My question is that on the front underside of the plenum(over top the thermostat) there is an open...
Forum: General Q & A
07-25-2007, 07:32 AM
Replies: 6
Views: 1,919
Posted By GSS0816

Check to see if this will work, only a few hours...

Check to see if this will work, only a few hours left...
Forum: General Q & A
07-22-2007, 05:32 PM
Replies: 7
Views: 2,677
Posted By GSS0816

If it is EFI or MPI, it is most likely your IAC,(...

If it is EFI or MPI, it is most likely your IAC,( idle air control)valve/sensor
Forum: General Q & A
07-20-2007, 11:27 AM
Replies: 5
Views: 2,997
Posted By GSS0816

depends on if you have alphas, or...

depends on if you have alphas, or bravos.According to the parts book if alpha part#861776A2, if bravo # 97350T-1. block off plate for y pipe.
Forum: General Q & A
07-15-2007, 09:30 AM
Replies: 6
Views: 561
Posted By GSS0816

Disconnect the tach at the coil and take for a...

Disconnect the tach at the coil and take for a test run, could be the tach causing the problem
Forum: General Q & A
07-11-2007, 07:36 AM
Replies: 4
Views: 811
Posted By GSS0816

Yes I think the problem could be cured with trim...

Yes I think the problem could be cured with trim tabs. I have a 23 Wellcraft nova, if the tabs are all the way up, she will bounce , but but the tabs down alittle and she smoths out.
Forum: General Q & A
07-10-2007, 09:35 AM
Replies: 12
Views: 1,233
Posted By GSS0816

My mistake, I thought you were referring to the...

My mistake, I thought you were referring to the raw water pumps. I agree with previous post, water pumps are usually specific(right/left hand)
Forum: General Q & A
07-09-2007, 07:10 PM
Replies: 12
Views: 1,233
Posted By GSS0816

Depending if your motors are left or right hand,...

Depending if your motors are left or right hand, look on the back of the pumps and you will see how to put the hoses for either right or left hand.
Steve
Forum: General Q & A
07-09-2007, 10:38 AM
Replies: 4
Views: 644
Posted By GSS0816

You don't want to adjust the trim limit switch,...

You don't want to adjust the trim limit switch, you have to use the trailer button/switch.
Forum: General Q & A
07-09-2007, 09:27 AM
Replies: 1
Views: 3,149
Posted By GSS0816

I believe it is 55 Gals

I believe it is 55 Gals
Forum: General Q & A
07-06-2007, 05:34 PM
Replies: 8
Views: 892
Posted By GSS0816

There is a pair on E Bay ...

There is a pair on E Bay
http://cgi.ebay.com/ebaymotors/QUICK-QUIET-11-EXHAUST-PORT-STBD_W0QQitemZ190129407902QQihZ009QQcategoryZ26451QQrdZ1QQssPageNameZWD10VQQcmdZViewItem


Steve
Forum: General Q & A
07-04-2007, 08:42 PM
Replies: 5
Views: 1,884
Posted By GSS0816

The mercruiser numbers are Pump 16792A1 and the...

The mercruiser numbers are Pump 16792A1 and the pulley is 73873A1. Hope this helps you
Forum: General Q & A
07-04-2007, 05:21 PM
Replies: 5
Views: 1,884
Posted By GSS0816

What year motor

What year motor
Forum: General Q & A
07-04-2007, 02:11 PM
Replies: 10
Views: 5,390
Posted By GSS0816

Thanks guys, after reading the mercruiser...

Thanks guys, after reading the mercruiser manuals, it looks like it just lays up against the bottom of the flame arrestor.
Forum: General Q & A
07-03-2007, 08:20 PM
Replies: 10
Views: 5,390
Posted By GSS0816

I am at a loss, I know it goes to the plenum some...

I am at a loss, I know it goes to the plenum some where, as the diagram shows,however where. When I got the set up, it had a plug or fitting missing in the front of the plenum, right above the...
Forum: General Q & A
07-03-2007, 04:32 PM
Replies: 10
Views: 5,390
Posted By GSS0816

Well when I look on the electronic parts disc it...

Well when I look on the electronic parts disc it shows both side being vented into a baffle then up via another tube. I just don't see where it goes. It is a 93-95 EFI set up.
Forum: General Q & A
07-03-2007, 01:11 PM
Replies: 10
Views: 5,390
Posted By GSS0816

502 EFI crankcase vent question

Hello I am new to the site, I have a question. I am converting my 502 mag which was carb ran, I now am installing an EFI set up(early 90's) on the motor. I can't find where to attatch the tubes from...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.