Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: CenturyUltra
Showing results 1 to 25 of 148
Search took 0.01 seconds.
Forum: General Q & A
07-31-2018, 08:46 PM
Replies: 5
Views: 3,025
Posted By CenturyUltra

Thanks for the replies I’ll be back to the boat...

Thanks for the replies I’ll be back to the boat Thursday and try to get more info and serial #
Forum: General Q & A
07-31-2018, 08:30 AM
Replies: 5
Views: 3,025
Posted By CenturyUltra

Bravo One vs. Bravo One Diesel

What are the differences if any between the two just gear ratio? These are the old Bravo One drives not newer stuff. I’m looking at a boat that has a big block gas motor but diesel out drive. ...
Forum: General Q & A
07-16-2018, 08:51 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Finally found problem after doing compression...

Finally found problem after doing compression test. One rocker arm nut had backed off enough to let rocker fall off to side of push rod and intake valve was not opening at all so only running on 7...
Forum: General Boating Discussion
07-16-2018, 08:45 AM
Replies: 0
Views: 511
Posted By CenturyUltra

egauges.com

Has anyone bought from them recently? I placed an online order last week and have been calling multiple times a day for the last week and nobody ever answers. No notification my order shipped...
Forum: General Q & A
06-12-2018, 08:52 AM
Replies: 2
Views: 619
Posted By CenturyUltra

I called it’s different. Thanks

I called it’s different. Thanks
Forum: General Q & A
06-12-2018, 06:55 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Put stock distributor back on and it runs the...

Put stock distributor back on and it runs the same so it’s not that. Going to check valve adjustment.
Forum: General Q & A
06-12-2018, 06:53 AM
Replies: 2
Views: 619
Posted By CenturyUltra

Steering cables interchangeable - Ssc12416 and ssc13016?

Foolishly I ordered a steering cable based on an internet search before removing mine for a 93 baja outlaw 24’. I ordered a ssc13016 but it has an Ssc12416 on it. It looks like they are for...
Forum: General Q & A
05-21-2018, 01:56 PM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Just got back to messing with this after a long...

Just got back to messing with this after a long winter. If it was a rev limiter issue wouldnt it noticeably break up instead of just not turn higher?
Forum: General Q & A
10-16-2017, 09:38 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

With the distributor problem did it break up or...

With the distributor problem did it break up or just not rev? I do not think mine is breaking up but it's hard to tell. It just seems to be running fine at 3500 and more throttle does nothing.
Forum: General Q & A
10-16-2017, 08:21 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

I do have the ready to run distributor. It will...

I do have the ready to run distributor. It will rev higher than 3500 not under load. I will switch to other motor and see if problem follows
Forum: General Q & A
10-16-2017, 08:04 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Ran the boat approximately 90 miles on Saturday. ...

Ran the boat approximately 90 miles on Saturday. Cruises at 45 mph perfectly at 3400 rpm but one motor still would not rev. It's not losing fuel pressure at wot. Unfortunately I did not get a...
Forum: General Q & A
10-13-2017, 06:46 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Plan to water test tomorrow and try switching...

Plan to water test tomorrow and try switching lines, pumps and carbs
Forum: General Q & A
10-12-2017, 04:10 PM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Changed fuel filter fuel in it looked perfect...

Changed fuel filter fuel in it looked perfect pulled line off pump and blew back in tank all clear. I do notice if if I let fuel pumps run with key on and don't start engines good running side is...
Forum: General Q & A
10-12-2017, 11:49 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

i did verify distributor was not loose but I will...

i did verify distributor was not loose but I will check with light
Forum: General Q & A
10-12-2017, 09:51 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Previously was earlier this summer

Previously was earlier this summer
Forum: General Q & A
10-12-2017, 08:47 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

Thanks for replies, it runs fine getting up on...

Thanks for replies, it runs fine getting up on plane where it's under load but rpms are lower which makes me think no internal damage to motor
Forum: General Q & A
10-12-2017, 08:22 AM
Replies: 29
Views: 6,242
Posted By CenturyUltra

502 Carb Runs Fine Except Won't Turn Over 3500 RPM

31' scarab twin 502 Carb motors, motors have low hours, ran good previously with no changes to setup, one motor now won't turn over 3500 rpm under load but runs fine otherwise, will rev higher out of...
Forum: Wanted
08-10-2016, 06:52 AM
Replies: 2
Views: 602
Posted By CenturyUltra

Gil tailpipe wedges

I need 4 tailpipe wedges ideally 5/8" but 1/2" should work. Albany ny area. Looking for used or cheaper than $230 a set. [email protected]
Forum: General Boating Discussion
04-16-2015, 08:12 AM
Replies: 4
Views: 4,347
Posted By CenturyUltra

I'm using srp 139483 pistons

I'm using srp 139483 pistons
Forum: General Boating Discussion
04-16-2015, 08:08 AM
Replies: 4
Views: 4,347
Posted By CenturyUltra

14096188 heads on gen6 502?

I'm putting together two gen 6 502s they came with 14096188 casting # heads are these decent heads for these motors? Two are cracked so trying to decide wether to find two or switch all 4? Thanks
Forum: General Q & A
04-07-2015, 09:14 AM
Replies: 3
Views: 892
Posted By CenturyUltra

Thanks! Are these decent cams?

Thanks! Are these decent cams?
Forum: General Q & A
04-06-2015, 09:11 PM
Replies: 3
Views: 892
Posted By CenturyUltra

Mystery 502 Cam?

Gen 6 502 cam numbers are 315826 and 411842. On the end it has B6PJ LM CG 12. I can't find anything searching the net does anyone know what this cam is? Thanks
Forum: Formula
04-03-2015, 06:49 AM
Replies: 16
Views: 4,252
Posted By CenturyUltra

Perfect I'll order them from Hardin I'd rather...

Perfect I'll order them from Hardin I'd rather have less holes in the boat anyway thanks guys
Forum: Formula
04-02-2015, 12:03 PM
Replies: 16
Views: 4,252
Posted By CenturyUltra

Yeah that might work I just want to cover holes...

Yeah that might work I just want to cover holes in seat since upholstery is fine. Anyone have two swim platform grab handles?
Forum: Formula
03-31-2015, 05:06 PM
Replies: 16
Views: 4,252
Posted By CenturyUltra

I was going to put bolsters from an 89 272 in my...

I was going to put bolsters from an 89 272 in my 88 242 but the rear rails are missing. I thought maybe I could find someone parting one with destroyed seats eventually that would give up the rails.
Showing results 1 to 25 of 148
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.