Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: PQ280SC
Showing results 1 to 13 of 13
Search took 0.00 seconds.
Forum: Powerquest
04-15-2011, 05:24 PM
Replies: 4
Views: 3,423
Posted By PQ280SC

Thanks boatnt. They don't have exactly what I'm...

Thanks boatnt. They don't have exactly what I'm looking for, but that's the best selection I've seen so far.

http://www.cmsquick.com/ has a pretty good selection of Contura II switches.
Forum: Powerquest
04-15-2011, 05:18 PM
Replies: 4
Views: 3,423
Posted By PQ280SC

not custom covers, just that the graphics are...

not custom covers, just that the graphics are custom. If you look on the Carling Technologies website you can find the standard switch legends, and none of them match my switches. PQ must have...
Forum: Powerquest
04-15-2011, 05:15 PM
Replies: 2
Views: 1,015
Posted By PQ280SC

I think you're correct. I found some dash pics...

I think you're correct. I found some dash pics for a 320 SC that's for sale with the switches labeled as trim tabs. I have the seperate lenco controller. Thanks.
Forum: Powerquest
04-14-2011, 04:24 PM
Replies: 4
Views: 3,423
Posted By PQ280SC

Carling Contura Switches

Anyone know of a place to buy rocker switch actuator covers with the PQ legends? I've looked around a bit, and it seems like PQ had the switch actuators customized.
Forum: Powerquest
04-13-2011, 12:13 AM
Replies: 2
Views: 1,015
Posted By PQ280SC

Rocker switches on dash

I have a 280 SC with (2) momentary on - off - momentary on rocker switches next to each other on the starboard side of the steering wheel. They are both protected by one breaker. Anyone know what...
Forum: Powerquest
10-12-2010, 06:31 PM
Replies: 1
Views: 1,181
Posted By PQ280SC

I use 11'6" as a minimum bridge clearance

I use 11'6" as a minimum bridge clearance
Forum: Powerquest
06-03-2010, 12:44 AM
Replies: 1
Views: 1,001
Posted By PQ280SC

I have run Mirage Plus 21's and Rev 4 21's on my...

I have run Mirage Plus 21's and Rev 4 21's on my 280SC
Forum: Powerquest
04-29-2010, 04:41 PM
Replies: 8
Views: 2,118
Posted By PQ280SC

not sure about your boat, but I have an 05 280SC...

not sure about your boat, but I have an 05 280SC (no windlass) and the wiring was already in place. double check before you go to the trouble of fishing a new wire.
Forum: Powerquest
09-12-2009, 04:32 PM
Replies: 3
Views: 939
Posted By PQ280SC

Thanks Rock Star. I'll break out the volt meter...

Thanks Rock Star. I'll break out the volt meter and investigate. If I remember correctly, the 12v supply between the battery switch and the panel wasn't a very large gauge, so that's the most...
Forum: Powerquest
09-10-2009, 02:54 PM
Replies: 3
Views: 939
Posted By PQ280SC

12 volt issues

Anyone ever have a problem with the DC panel? I'm having trouble with the refer when at anchor running on the battery. Just put a new battery in and the refer runs fine when the engine is running or...
Forum: Drives and Lower Units
06-30-2009, 06:11 PM
Replies: 7
Views: 1,246
Posted By PQ280SC

The boat is a 280 PowerQuest Sun Cruiser. Twin...

The boat is a 280 PowerQuest Sun Cruiser. Twin 350's, a large swim platform and an arch make it very stern heavy for a 28 footer. I haven't gotten the boat up on straps, but I think the CG is too...
Forum: Drives and Lower Units
06-22-2009, 10:58 AM
Replies: 7
Views: 1,246
Posted By PQ280SC

under certain circumstances either the deeper...

under certain circumstances either the deeper drive (stb) seems to hookup better or the more shallow drive (port) looses bite and the boat would violently pitch port side high. That was with the...
Forum: Drives and Lower Units
06-21-2009, 09:38 PM
Replies: 7
Views: 1,246
Posted By PQ280SC

uneven drives

any suggestions for evening up a pair of bravo 1's that are 1/4 inch off from one another? my port side drive is mounted 1/4 inch higher on the transom, which I supsect is the reason for some...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.