Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: elise909
Showing results 1 to 11 of 11
Search took 0.00 seconds.
Forum: General Q & A
09-09-2009, 04:07 PM
Replies: 15
Views: 1,552
Posted By elise909

Stick w the 4 blade. 3blades do not do good on...

Stick w the 4 blade. 3blades do not do good on power boats. The 4bl26 sounds pretty close to where you need to be at wot rpm. Maybe a 4bl 24 w cup will put you at a 25p. That will probally get you...
Forum: General Q & A
09-08-2009, 01:21 PM
Replies: 11
Views: 1,690
Posted By elise909

Post Sorry for the typo; well said wtfo.

Sorry for the typo; well said wtfo.
Forum: General Q & A
09-07-2009, 05:31 PM
Replies: 11
Views: 1,690
Posted By elise909

Each number you change expect a 200-300 rpm...

Each number you change expect a 200-300 rpm change. A 21 will probally give you 400-500 more rpm. 4200 rpms on your first run a 21 will proballly get you closer to 4600-4700 rpm. Some times you...
Forum: General Q & A
06-22-2009, 03:15 PM
Replies: 12
Views: 1,837
Posted By elise909

Its burned into the computer I believe. I sent...

Its burned into the computer I believe. I sent mine to whipple to be reburned from factory 5350 to 5600 upon whipple install
Chris, hp500efi 2002
Forum: General Q & A
06-04-2009, 03:12 PM
Replies: 13
Views: 11,669
Posted By elise909

I have been thru this problem. Probally have...

I have been thru this problem. Probally have rocks or debris in the cooler. I had to remove all of my coolers and flush them out its a ***** to do . Oil temps will run higher than water temps. ...
Forum: General Q & A
06-01-2009, 03:04 PM
Replies: 7
Views: 948
Posted By elise909

Question need help figuring speed

I have a 02 29' fountain fever. I have a bravo1 xr 1.5 drive with a mercury bravo 1 lab 31p , the motor is running 5500 rpm . My speedo does not work and I do not have a gps. Can any calculate my...
Forum: General Q & A
05-07-2009, 08:20 PM
Replies: 0
Views: 642
Posted By elise909

Question whipples manifold gaskets

I did a sea trial on a whipple stage 1 on a 02 hp 500efi. Every thing worked properly except the atomized fuel spraying from between the paper thin manifold gasket. They did not instruct to use...
Forum: General Q & A
04-21-2009, 09:39 AM
Replies: 2
Views: 769
Posted By elise909

Help determining prop pitch

I own a Fountain 29' fever single engine hp 500 efi. It was running a Bravo 1 26p at 5200 rpm wfo. I have installed a Whipple Stage 1 kit. I was told to get a BRavo 30p or a Maximus 28p . Do you...
Forum: General Q & A
12-28-2008, 10:14 AM
Replies: 22
Views: 21,338
Posted By elise909

Question Whipple or Pro Charger ?

Was going to buy a Whipple charger then did some more research and I have almost decided to change and get a Pro Charger. The Pros;The ;Pro Charger is half the cost, also a 3yr. Warranty vs. 1yr....
Forum: Drives and Lower Units
08-04-2008, 05:16 PM
Replies: 2
Views: 2,469
Posted By elise909

2002 fountain fever 29'

I purchased a 2002 Fountain Fever this spring. This boat was tested at Fountain on a 40 degree day and ran 77 MPH @5350 rpm with a mercury 26p. After my sea trial I felt that the boat need more prop...
Forum: Detailing, Painting, & Fiberglass
05-27-2008, 02:25 PM
Replies: 2
Views: 1,037
Posted By elise909

Re: removal of mineral or water depostis .

I have a new Fountain , and from being in the water at Lake Texoma over the weekend the prop,transom and all the braided lines have a coating of calcium or something covering all these pieces. My...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.