Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 3 of 20
1
2
3
4
5
13
Last »
Search: Posts Made By: blown formula
Showing results 51 to 75 of 500
Search took 0.03 seconds; generated 105 minute(s) ago.
Forum: Wanted
04-11-2008, 09:15 PM
Replies: 3
Views: 696
Posted By blown formula

Needed asap! Bravo Prop shaft

My propshaft is twisted & I am building a pair of 2" shorties. One propshaft is slightly twisted so I am looking for a good used one... or a deal if possible.
Thanks
Forum: General Q & A
02-09-2008, 09:09 PM
Replies: 5
Views: 2,069
Posted By blown formula

We have used Lightning's headers for over 5...

We have used Lightning's headers for over 5 years... excellent performance, no cracking or rust issues ever. We do however use automatic drain tubes on the headers to drain after every time in the...
Forum: General Q & A
02-09-2008, 01:21 PM
Replies: 18
Views: 25,945
Posted By blown formula

Put an AUTOMATIC DRAIN on your headers. Just use...

Put an AUTOMATIC DRAIN on your headers. Just use a fitting at the rear of each each headers water tube, "t" fitting the two lines together then install a thru-hull fitting below the water line. When...
Forum: General Q & A
02-09-2008, 12:08 PM
Replies: 1
Views: 696
Posted By blown formula

Mine have all been .500.... use brass gears. If...

Mine have all been .500.... use brass gears. If they failed it will not destroy your bearings.
Forum: General Q & A
02-09-2008, 12:02 PM
Replies: 25
Views: 5,763
Posted By blown formula

As far as your speed goes... my buddies '91 29...

As far as your speed goes... my buddies '91 29 Fever runs 94mph on GPS.... really squirrley at that speed though. Tough to drive.
t-502's, .060 over, special cams, rockers, stock GM heads,...
Forum: General Q & A
02-09-2008, 11:31 AM
Replies: 8
Views: 18,555
Posted By blown formula

Spend the bucks and buy a high torque starter...

Spend the bucks and buy a high torque starter with a billet nose piece. The nose piece is indexable for clearance and will NEVER break. I had the same thing happen, only I have twins and of course it...
Forum: General Q & A
02-09-2008, 11:18 AM
Replies: 4
Views: 1,630
Posted By blown formula

I have bought several sets of decals off ebay...

I have bought several sets of decals off ebay from "spots" at a reasonable price.:cool-smiley-026:
Forum: Sonic
01-23-2008, 02:25 PM
Replies: 213
Views: 32,365
Posted By blown formula

thanks!! sryy fot thr no caps, but i just got...

thanks!! sryy fot thr no caps, but i just got out of the hospital toda @ noon after shoulder surgery and i can only use my left hand for now. it sucks big time!! thanks again.
george
Forum: Sonic
01-16-2008, 09:48 PM
Replies: 213
Views: 32,365
Posted By blown formula

Talking Actually, Sunchaser, those valves were never...

Actually, Sunchaser, those valves were never "really" installed with the engines but were remove for that very reason. Other things have changed also when the engines came out last time. A different...
Forum: Beware and Stolen
01-06-2008, 06:02 PM
Replies: 1,036
Views: 307,792
Posted By blown formula

Yes it was. I have never replaced every single...

Yes it was. I have never replaced every single piece of a boat before... even the wiring, head & refrigerator. But I have a "new" boat now, unlike anything else around here anyway.
An education......
Forum: Sonic
01-05-2008, 03:52 PM
Replies: 213
Views: 32,365
Posted By blown formula

I just found out about the bad deal with Fred,...

I just found out about the bad deal with Fred, Trick Marine (Too Old),,, so I changed the name of the thread to The blown formula sonic project now... too much bad press on Fred. I do not wish to be...
Forum: Beware and Stolen
01-05-2008, 03:13 PM
Replies: 1,036
Views: 307,792
Posted By blown formula

I was reluctant to post this before as I did not...

I was reluctant to post this before as I did not want to hurt Fred good "rep" here. But no longer... when I bought the Too Old Sonic" from Fred, I waited to regster it in Okla.... unfortunately I...
Forum: General Q & A
10-20-2007, 04:45 PM
Replies: 0
Views: 760
Posted By blown formula

Arrow Need a pictures-Returning engines to stock.....

Could someone email me or post a picture of a stock '97 454 Mag efi? I am removing my Prochargers & making it stock again (as close as possible). I did not do the installation, & it seems I cannot...
Forum: Sonic
08-05-2007, 01:52 PM
Replies: 213
Views: 32,365
Posted By blown formula

Thanks for the kind words..... The answer to...

Thanks for the kind words..... The answer to your question are many & varied. My wife says I did it because I never "bonded with the 312 Formula like I did my Formula 252. What she means is I never...
Forum: Sonic
07-25-2007, 04:47 PM
Replies: 213
Views: 32,365
Posted By blown formula

Thanks alot , MSTG72... I enjoy the boat more...

Thanks alot , MSTG72... I enjoy the boat more everytime we take her out...... now those critics (local to here) are eating their words about never getting it done. It is the most distinctive boat on...
Forum: Drives and Lower Units
07-14-2007, 09:00 PM
Replies: 11
Views: 2,533
Posted By blown formula

Thanks, Rene.... that is close enough!! My...

Thanks, Rene.... that is close enough!!

My Formula, per the spec sheet from the factory says 1.5:1 drives...... but this issue is with my Sonic 30SS......
This boat still remains a mystery in...
Forum: Drives and Lower Units
07-13-2007, 04:27 PM
Replies: 11
Views: 2,533
Posted By blown formula

Ok, that works out to lower drive ratio of 1.27...

Ok, that works out to lower drive ratio of 1.27 in the lower.
So, 1.18 upper
1.27 lower

Is that a final drive ratio of 1.5:1????
Come on math whizzes!! Clue me in!!:drink:
Forum: Drives and Lower Units
07-13-2007, 02:27 PM
Replies: 11
Views: 2,533
Posted By blown formula

No, this is just the upper housing pinion &...

No, this is just the upper housing pinion & gearset 27/32. The lower units on Bravo 1's I thought were all 1:1 ratio, but mine is slightly different from that.... about 1 1/8th turn on vert shaft to...
Forum: Drives and Lower Units
07-13-2007, 01:50 PM
Replies: 11
Views: 2,533
Posted By blown formula

Gear Ratio- I'm confused??

I just disassemble my Bravo 1.... on another thread OSO members were convinced I had 1.36 gears (based on speed & RPM's). However on disassembly I found the pinion is 27 teeth & the drive gear set...
Forum: Sonic
06-22-2007, 08:53 PM
Replies: 213
Views: 32,365
Posted By blown formula

:cool: (cool) & slightly embarrassed!! Thanks...

:cool: (cool) & slightly embarrassed!! Thanks for the kudo's my friends. I don't know that I deserve them. It has been rewarding & at the same time extremely frustrating!! Now the payoff starts....
Forum: Formula
06-21-2007, 09:51 AM
Replies: 22
Views: 3,883
Posted By blown formula

Here is the ad on TRADERONLINE ...

Here is the ad on TRADERONLINE

http://adcache.boattraderonline.com/6/5/6/89235056.htm

I will pay travel expense & deliver the boat as part of a deal also........
Forum: Formula
06-20-2007, 10:36 PM
Replies: 22
Views: 3,883
Posted By blown formula

I see another 312 on the OSO ads for the same...

I see another 312 on the OSO ads for the same price, same year, no hours are quoted. Is that because there are a lot of them?? Who knows! Mine has VERY low hours which should add to it's value &...
Forum: Formula
06-19-2007, 04:58 PM
Replies: 22
Views: 3,883
Posted By blown formula

Phantom, No that is not my boat. Mine only...

Phantom,
No that is not my boat.
Mine only has 224 hrs on it. It is maintained by a Merc mechanic locally. It has a new full cover, cockpit cover & Bimini top also. The upholstery is near...
Forum: Formula
06-18-2007, 09:31 PM
Replies: 22
Views: 3,883
Posted By blown formula

Bayliner NOT!! The bolsters & floor alone cost...

Bayliner NOT!! The bolsters & floor alone cost over 10% of the asking price! I guess a lot of people don;t realize the quality of a Formula as compared to many/most mass produced boats..... I do...
Forum: Formula
06-18-2007, 05:36 PM
Replies: 22
Views: 3,883
Posted By blown formula

Question Why?? Just tire kickers, no buyers!!

I have started to advertise my 1997 312 Fastech for sale @59,900....Yacht trader, bargain Posts, etc..... large picture ads too.
it only has 224 hrs total & is almost pristine, but everybody wants...
Showing results 51 to 75 of 500
 
Page 3 of 20
1
2
3
4
5
13
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.