I need to remove the nose cones on a set of B-One's. Does anyone have any ideas on how to do this?

I did it once with TRS drives. They were the stainless steel type which were applied with some sort of adhesive.
I chipped/ground out the fairing epoxy to the edge of the nose cone & then put a block under the drive (not the nose cone) & gave the cone one good wack with a medium/small sledge hammer. They popped right off

I was thinking the samething. Thanks

I was going to take one of an Alpha, but when I got the sorry epoxy job taken off, I found the water intakes were full of epoxy, so now I'm just going to fair it back in.