Water Dumps

Reply Subscribe

Thread Tools

11-16-2007 | 06:16 PM

nordic95

Thread Starter

Registered

Joined: Aug 2005

Posts: 1,845

Likes: 3

From: New Jersey

Water Dumps

Does any one know where I can get a water dump like this with the 45 degree angle but with a thread on #8 or #10 on the inside.I need it 3 inches long or so to make it thru the transome of my boat.

Thanks in advance

Nordic95

Attached Images

11-16-2007 | 06:45 PM

nocigarette

Gold Member

Joined: Mar 2003

Posts: 2,376

Likes: 94

From: Grosse ile michigan

i dont think they make them........not sure.........Your best bet is buy it and take it to a welder and have him weld a an steel fitting to it......I have done that quite a bit on various plumbing issues i have had...

11-16-2007 | 07:12 PM

CIG3

Registered

Joined: Jan 2001

Posts: 2,292

Likes: 20

From: Grand River, Ohio

Stainless Marine can hook you up.

11-17-2007 | 09:31 AM

ls1nova

Registered

Joined: Jul 2004

Posts: 388

Likes: 1

From: Cecil County, Maryland

Could you buy one of the one's that comes out straight, then use a 45* fitting.

11-17-2007 | 12:17 PM

Panther

Frank's Marine Service

Joined: Sep 2002

Posts: 11,959

Likes: 142

From: Elkton, MD

Quote:

Originally Posted by ls1nova

Could you buy one of the one's that comes out straight, then use a 45* fitting.

My guess is yes! The small dumps I use for the rear of my intake manifold are threaded all the way thru the inside, as well as the outside with a -8 fitting I believe.