Precision Marine, Kenner La.
#1
Thread Starter
Registered
Joined: Jun 2004
Posts: 444
Likes: 1
For any one that needs any kind of computer tuning or HP stuff this is your place. I recently did some upgrades to my 500 EFI , Blower, Aluminum Heads, etc...and it needed some fine tuning to get it right, I sent the ECU down , Mark got it very close the first time but he told me the best way was to tune it in the boat. Well I made the 500 mile trip, keep in mind thaat is each way, and it is now dead on perfect. He and the guys down there run a first class operation, great shop, great hardware and all around just a great bunch of guys. A lot of people think they are EFI guru's but Mark can back it up, when the time comes to build a big EFI Motor this is where I am going.
Hey Mark, fun running in the canal for sure but next time once I have the big tabs on my boat we can run out in the lake. Kind of a strange experience running over 85 in a canal maybe 100 ft wide and only 6 feet deep.....
Thank you!
Bryan
Hey Mark, fun running in the canal for sure but next time once I have the big tabs on my boat we can run out in the lake. Kind of a strange experience running over 85 in a canal maybe 100 ft wide and only 6 feet deep.....
Thank you!
Bryan
#3
Mark Boos is the best I have found. He knows how to make the computers sing and has gone out of his way with every project he has done for me.
You would be suprised to know how many engine builders across the country Mark helps with computer programs.
You would be suprised to know how many engine builders across the country Mark helps with computer programs.
#5
It is catching on!
Heck, there are 90 mph Baja's and Fountains. I could never see why it was not done in big single Donzi's.
After getting dusted by an 85 mph Baja last year, we all went back to the drawing board.
Heck, there are 90 mph Baja's and Fountains. I could never see why it was not done in big single Donzi's.

After getting dusted by an 85 mph Baja last year, we all went back to the drawing board.
#7
Registered
Joined: Jan 2007
Posts: 192
Likes: 0
From: Laplace,LA
They are pretty good with a outdrive too. He's taken care of me a couple of times and had me ready for the weekend, actually I have to pick up my drive tomorrow morning.
And his prices are hard to beat for the work you get.
Scott
And his prices are hard to beat for the work you get.Scott
#9
Thread Starter
Registered
Joined: Jun 2004
Posts: 444
Likes: 1
#10
Registered
Joined: Jul 2007
Posts: 988
Likes: 2
From: San Diego


