36 Skater Project
#622
Platinum Member
Platinum Member
#623
Registered
Join Date: Apr 2001
Location: Atlanta / Ft. Myers Fl.
Posts: 794
Likes: 0
Received 0 Likes
on
0 Posts
Do you have sump tanks with additional fuel pumps? Marty made some for my 28 fuel from Skater tank pumped via Holley Red pump into custom sump tank then Bosch pump to the motors....
#624
Platinum Member
Platinum Member
Steve,
Yes Skater took out everything that had been installed, and started over with new tank pick ups, water separators, holley red low pressure pumps, surge tanks, merc hi pressure pumps, then fuel pressure sender
Yes Skater took out everything that had been installed, and started over with new tank pick ups, water separators, holley red low pressure pumps, surge tanks, merc hi pressure pumps, then fuel pressure sender
#625
Registered
Join Date: Aug 2007
Location: West Michigan
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
I would verify the fuel pressure with a manual gauge, if you were having fuel delivery problems I wouldn't think all 4 fuel pressure gauges would read the same. Check at start up and while running if possible, and make sure the manual one matches your electric ones.
#626
Platinum Member
Platinum Member
Manual FP gauge says I've got 38 lbs. go figure, all four dash gauges reading 31.
Next move for me is go through all connections of engine harnesses on center engines, and make sure of no soft grounds
Next move for me is go through all connections of engine harnesses on center engines, and make sure of no soft grounds
#627
Platinum Member
Platinum Member
[ATTACH=CONFIG]504708[/ATTACH]I was able to get the Skater to Buckeye Lake yesterday to launch for the first time
Last edited by davidmercury; 07-19-2013 at 01:15 PM.
#628
Registered
#629
Platinum Member
Platinum Member
first time out with 36 skater.wmv please try to overlook the cheesey music
I was amazed at how easily it planed with the engines trimmed at level.
I really liked the sound of the Quads. Trying to break the powerheads in, but pushed forward a little and saw 90 real easy. No porpoise either. So far, beyond my expectations.
I was amazed at how easily it planed with the engines trimmed at level.
I really liked the sound of the Quads. Trying to break the powerheads in, but pushed forward a little and saw 90 real easy. No porpoise either. So far, beyond my expectations.
Last edited by davidmercury; 07-19-2013 at 01:47 PM.
#630
Platinum Member
Platinum Member
Attachment 504710 please try to overlook the cheesey music
I was amazed at how easily it planed with the engines trimmed at level.
I really liked the sound of the Quads. Trying to break the powerheads in, but pushed forward a little and saw 90 real easy. No porpoise either. So far, beyond my expectations.
I was amazed at how easily it planed with the engines trimmed at level.
I really liked the sound of the Quads. Trying to break the powerheads in, but pushed forward a little and saw 90 real easy. No porpoise either. So far, beyond my expectations.