Good find Lightspeed. I was looking in rub rail, but there it is in trim / moulding. Thanks.
Thanks Sam. I just need 3 good sticks. May be a booger to ship. This stuff looks pretty stout on the boat, but when you have a 10' piece in your hands it's very flimsy.

Flight, Just sandwich the sticks between some 1"x3" pieces of wood. That worked for me when I shipped some to New York from Mich. They made it without incident. Be sure to put FRAGILE and DO NOT BEND on the pack FYI.............. Good luck with her :)

Anyone know where I can pick up a couple sets of these stainless transom plates. I want to leave these on the 32. I see some have them and some dont. Looks like a good idea for a painted hull.

Just go to a metal shop and have them cut some flat stock for you. Make sure you get them polished!!!! A must for a nice look and no rust stains.

I have three in my shop from my 28. The fourth in on my duck boat..if you have a junk SS plate about that size for my duck boat I can hook you up.

Maybe we should start a Skater swap shop thread!

I'm not quite sure how to take this one Sam. HaHa! More coffee maybe...

OOOPs! Guess I should wait until the caffeine kicks in before I post!:lolhit:

Ok, we had a very busy summer with very little free time. 28-1 has been on the back burner.

Time to get back to work. Parts are starting to flow in. Here we go.

Spare gear cases

[ATTACH=CONFIG]546961[/ATTACH]

Seating options found local, go figure.

[ATTACH=CONFIG]546962[/ATTACH]

The cover was a pleasant surprise. Needs a few repairs, but very usable for time on the lift.

[ATTACH=CONFIG]547014[/ATTACH]

Why do all you guys have such clean shops??? Mines not happy unless you have to crawl over something to get to the boat or look 15 minutes to find a ratchet.

you could ship those rails in a pvc tube