The new boat....a 30 CC
05-13-2010 | 06:52 AM
#721
Thread Starter
Registered
Joined: Sep 2007
Posts: 706
Likes: 0
partially correct on that....yeas i wanted to cut the pans first but we were still waiting on the tie bar.....it was kinda on intergalactical back order..
it came in today along with your lobg awaited eddie marine oil tank brackets....
here is a pic of todays bounty courtesy of the UPS man.....
and here is the aftermath ofmeasuring, marking, hacking, grinding, sanding and painting of your lower cowls.....they are all done and one has even been installed although i forgot to take a pic...
as a teaser the finished product looks something like this.....
goodnight...need my sleep so i am fresh in the morning....
it came in today along with your lobg awaited eddie marine oil tank brackets....here is a pic of todays bounty courtesy of the UPS man.....
and here is the aftermath ofmeasuring, marking, hacking, grinding, sanding and painting of your lower cowls.....they are all done and one has even been installed although i forgot to take a pic...
as a teaser the finished product looks something like this.....
goodnight...need my sleep so i am fresh in the morning....
05-15-2010 | 01:50 PM
#724
Registered
Joined: Oct 2000
Posts: 611
Likes: 0
Darren the lower cowls have to be cut about 3 inches almost all the way around to accomodate the latham steering plates...its a tedious job gettint them to line up and look good without leaving a huge gap between the plate and the cowl....and them once they are cut nicely the edges are white fiberglass type material so i paint the edges with a few coats of phantom black just to clean it up a bit....
05-15-2010 | 07:13 PM
#725
Registered
Joined: Jan 2008
Posts: 5,221
Likes: 620
From: Jersey Shore
Just as an FYI,
MarineMachine in FL does the same wing plate for the Verado line. you have to make the same cut in the rear of the cowling. Latham does not make this for the Verados.
I will be updating MarineMachine.com to show you guys the pics of the wing plate made for Verados.
MarineMachine in FL does the same wing plate for the Verado line. you have to make the same cut in the rear of the cowling. Latham does not make this for the Verados.
I will be updating MarineMachine.com to show you guys the pics of the wing plate made for Verados.
Last edited by noli; 05-15-2010 at 07:30 PM.
05-19-2010 | 08:30 PM
#727
Registered
Joined: Oct 2000
Posts: 611
Likes: 0
started work on the inside of the console.....coming along now....
tabs are on and were a tight fit....
Sean ordered a real cool stern light....all stainless and looks pretty neat in the package...cant wait to install it...
Left Hand sportmaster came in today....
tabs are on and were a tight fit....
Sean ordered a real cool stern light....all stainless and looks pretty neat in the package...cant wait to install it...
Left Hand sportmaster came in today....
05-19-2010 | 09:21 PM
#728
Thread Starter
Registered
Joined: Sep 2007
Posts: 706
Likes: 0
You da man....looking great!!
