New noisemakers.

A few progress pictures. Engines are coming together and should be going to Nickerson's shop to be tuned on the dyno next Tuesday. They are getting Aeromotive 750 fuel pumps and all braided lines. The new Imco manifolds should be in tomorrow. Fabrication of the one piece risers will have to wait until the engines are in and a mock up can be made. The Loncoin II floor is cut and laid in place to relax before installation. The finished dash - fancy! The bilge is cleaned out, scuffed down and ready for paint this week. Next week it should get the holes and chips in the dash fixed and gel coated. The seats are getting new plywood in some areas and should go to the upholstery shop later this week.

Jammin',Lookin' real nice !!

Thanks. Your boat is 45 minutes from me. I've been tempted to take a peek.

Jammn, Your closer than me ! Take a peak,anytime!

Beautiful job!

Jammin are the rocker switchs used for any the trims. Or are you using the switches on the throttles for everything?

The boat looks great hope to see it this summer.

I'll have drive trim on both. Waiting on diodes now to protect the switches. I'm looking forward to seeing it on the water too!

Looks awesome!! You should make the tow from Maryland when we get a Sutphen run going!!

Lookin good !