Parts for trade
09-10-2008 | 12:02 AM
#1
Thread Starter
Registered
Joined: May 2004
Posts: 1,218
Likes: 2
From: Blanchard, OK
Parts for trade
I have some parts laying around that I would like to trade or make offer.
I have:
2- Bravo inner transom plates that are new takeoffs.
2-B/W Bellhousings for small or big block chevy. Sorry no tranny coolers
TRS inner and outer transom assembly. Around 20 hours total time on it.
Speedmaster Clubfoot drive with transom assembly.
Small block MPI injection system with distributor. Sorry no controll computer or harness.
New 36 Gallon Tempo fuel tank with sending unit-Outsid e covered in dust from storage.
Needed:
2-TRS Hydromotive Nosecones
Dual TRS hydraulic steering
2-Water pickups
2-through transom cable keepers(Drive indicator cables)
2-large air cleaners or approved CG arrestors for single carb blower engine.
or ??
Thanks
Steven
I have:
2- Bravo inner transom plates that are new takeoffs.
2-B/W Bellhousings for small or big block chevy. Sorry no tranny coolers
TRS inner and outer transom assembly. Around 20 hours total time on it.
Speedmaster Clubfoot drive with transom assembly.
Small block MPI injection system with distributor. Sorry no controll computer or harness.
New 36 Gallon Tempo fuel tank with sending unit-Outsid e covered in dust from storage.
Needed:
2-TRS Hydromotive Nosecones
Dual TRS hydraulic steering
2-Water pickups
2-through transom cable keepers(Drive indicator cables)
2-large air cleaners or approved CG arrestors for single carb blower engine.
or ??
Thanks
Steven
Last edited by Prater; 09-10-2008 at 12:04 AM.
09-19-2008 | 06:51 AM
#5
Registered
Joined: Jan 2004
Posts: 1,571
Likes: 0
From: Saint Petersburg Fl
I need to stop being slack and re-new so I can send PMs, but how much for the MPI manifold? e-mail to [email protected] if you wnat.
Thread
Thread Starter
Forum
Replies
Last Post
kswest
General Boating Discussion
24
04-06-2006 02:24 PM
