I’m looking to sell my Superboat. It’s a 2000 Stepbottom 24’. It has a Merc 250 EFI that is bone stock never touched all original. It runs very strong and smooth.


It’s equipped with:


* Gaffrig controls and guages (Speedo, Tach, water pressure, water temperature, depth finder, trim gauge, floscan GPH gauge) all with red bezels
* Hydraulic trim tabs ( K-planes)
* CMC 5.5” Hydraulic Jack plate
* Hynautic Hydraulic Steering
* Newly installed Stereo with Alpine head unit and JBL Marine 6x9s in the rear and 6.5s up front
* Drop down/stand up bolster seats
* Finished cabin with cushions and lights and whatnot
* custom snap-in Cockpit Carpet made for the boat (there’s also a piece of carpet in the cabin)
* Boat comes with 3 covers --> cockpit cover, Full boat cover, and outboard engine cover


I had the upper and lower engine cowls repainted a few weeks ago and new decals put on it so it looks a bit more color coordinated with the boat now


The boat handled whatever I had the gonads to throw at it… which doesn’t say much tho, lol… I’ve put 6 people in it a few times (petite women anyway) otherwise u can run 5 people comfortably all the time. have run it in dead glass to some good weekend windy chop in the GSB, and from other people on the forum helping me out I was able to get my hands on almost 15 props in the past few months seeing what they did for the boat. As currently setup she’s good for 69-70 GPS mph with a 23-24 tempest plus or 25-26 trophy plus... I've never run the boat on low gas or fumes like some of you... to chicken to run out of gas, i top it off everytime i run the boat


Boat currently has a little 21 trophy (63ish mph) which gets it up on plane in a hurry and gives good characteristics when I have the boat loaded with 4-6 people and a full tank, but this prop hits the limiter hard when your running with a light load 2 people on board. That’s where the other props mentioned above really shined and added 5+ mph.


Boat is currently in Seaford, Long Island where I keep it at a High and Dry facility. (zip code 11783) Another week or two I’m planning on winterizing and moving it onto dollies and putting it inside a heated shop that I work at for the winter.


$25,000 OBO. Will not separate the hull/motor, sorry.… It’s turn-key ready to go


Thanks! Let me know if you need specific information I missed, or other detailed pictures, etc. Can be reached by PM, e-mail, or phone.


Steve
[email protected]
516-817-1903 (cell)

bump... happy holidays everyone

finally getting some phone calls and e-mails and people looking at the boat!

The boat is now indoors inside a heated shop if you would like to take a look at it and go through it... slowly going through it while its inside for its periodic detailing.