|
whats the dimension of propshaft to input shaft compared to to a standard Bravo setup?
|
Originally Posted by tssteph
(Post 2778415)
whats the dimension of propshaft to input shaft compared to to a standard Bravo setup?
Need to mess. a bravo first,dont have one .But i can mess a #3 and let u know. |
Ok,,,X-DIM. = 24 & 9/32 between center of yoke and center of propshaft.
Hope this helps u. |
Do they come with the Transom Asemblies ( Inner and Outer )
|
Originally Posted by ALMOST RUINED
(Post 2779614)
Do they come with the Transom Asemblies ( Inner and Outer )
|
TSP, I have a pair of #2's, fresh, 0 hours. Let me know if you're interested. You can email me at [email protected]. I also have two pairs of BW 72C's, a Merctrans, a couple of TRS gimbals with rams and a fresh pair of 0 hour 496 Mk. IV long block stroker motors as well. Looking to sell it all.
Thanks, Harry |
Originally Posted by Cig35Mistress
(Post 2780796)
TSP, I have a pair of #2's, fresh, 0 hours. Let me know if you're interested. You can email me at [email protected]. I also have two pairs of BW 72C's, a Merctrans, a couple of TRS gimbals with rams and a fresh pair of 0 hour 496 Mk. IV long block stroker motors as well. Looking to sell it all.
Thanks, Harry http://www.offshoreonly.com/forums/w...sm-drives.html |
Thanks! I had seen that earlier and emailed him, just waiting on a response.
|
| All times are GMT -5. The time now is 07:49 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.