I have a 272 formula that im not going to finish. Id rather focus on my Cafe and get that back together and ready to run. Its bigger then I wanted as i was looking for a 24x7. The boat is almost dont but needs a few things
What has been done:
Drive rebuilt
New Trim Pistons- Both sides
Bellows/Shifters/Gimbal Bearings- Both Sides
SunPad Rear Seat recovered
Cabing Door New
Fuel Pumps Replaced-Holley
Fuel Water Sep. New
Spark Plugs- New
Oil just changed
Oil filter just replaced Also
Just bought 23P Cleavers for it with new Hardware (lock washer nuts)
Interior Arm Rest recoverd
New Carpet and Step in cabin
New Tires
Wheel Bearings
Seals

Has to be done:
Stbrd Thru Hull-
Pull Motor, Take out Y Pipe, Replace with block off plate (i have it) Also have the Tips
Finish recovering interior, I have the material for it.
Set timing on engines
Replace belts
Set Shift points for drives, Alpha
Set Shift cable distance
Trim Tabs dont work but its all there
Running lighst inop
Docking lights inop
Needs fuel sender wiring good
Needs Temp sender for stb engine, pegged hot
Need side windows in windshiled, Missing when i bought it
Cabin door need to be put on, Missing hinges and Handle, New door i had cut is included
I will deliever with in reason if needed just get a hold of me and we talk it over.
Trailer was build to the boat not just an off the lot trailer in 97. All fresh water Winni Boat.
Asking 9K OBO just want it out of my Cafe space.
Thanks
-Mike

The boat is an LS and has small Block 350/260's. Should run in the low to mid 50's
-Mike

Also has a full tank of 93 fuel and rebuild carbs. Its a 30th annevrsery edition

Nice,

Not ready to part with my 24x7 yet though

Come On!!!!!!!!
-Mike

what do these typically sell for when complete?

12-15K. The Hull is in excellent shape. Front rollers just replaced on the trailer with Stolts non marking. I covered the port side couch seats last night. set the timing. I also mach'd up the sbt side exhaust. I have a set of risers coming so it will all be there. If i get to do it I do if not all parts are there to complete.
-Mike

Replaced trim limiter switches and needed a coil so put a blaster 2 in it. Cutting exhaust holes tonight. Window templates are made just needs to be cut those go with it so ou can get a piece of glass cut. I have an extra 23P quicksilver prop ill throw in the boat along with everything else. Anyone with a 24x7 want to move up? It really only need small stuff to finish. A solid weekend it will be done. Ive had it out already. Runs good but need to be finished. Everything is there just needs to be finished.
-Mike

Just dropped in 2 850 amp batts. interstate and cut the holes for the thru hull. I really dont want to pull the engine and put it in ive been working on the cafe and need this gone any reasonable offer its gone and help with del.
-Mike

Interior seat just redone. here is a pic
-Mike