2 fresh huber 1050's
 

These were built by Texoma marine gear on referal from Earl about 3 or 4 years ago and sealed.

Still sitting on the shipping pallet with the instructions attached.

1 is a 72C with a TRS tail. The other is a 72C built for a driveshaft configuration.

Sell them both for $750 plus the freight. I have just that much in the cases before I had them built.

Don't think I am going to use them. Make me an offer.

Jeff, I think I want these as well, just looking into the cost to change the driveshaft configuration to a trs tail.
Hold off on shipping those gauges.

You can't change the driveshaft to a TRS tail, but let me check my stock, I think I have some extra cores, and yo can have Earl build you another one.

I can let you know tomorrow.

Jeff

velvet drive
 

jeff1000man, did you get my pm?

Jeff,
I will take the 1 with trs tail, and if you can put together the parts for the second, that would be great. Let me know the total.
Thanks,
Mike.

pm me your number again and I'll call you in a little while.

no u cant, u basically need to change most of the internal parts to do so, and the housing (inside) is different as well !!!

:party-smiley-004:

Jeff driveline still avail ??? know someone in need

Yeah, basically that is why it is called a Huber and is no longer a velvet drive.... Oh, and why it costs so much damn money,

Until someone pays me for it, yes.

Spend some of that money you made today big guy.