2 used big block chevy 454 motors, gen 4 bowtie blocks,merlin heads,crane roller rockers,10 qt canton pans, gm forged cranks , dimple rods , wiend intakes , 850 holleys. hyd. flat tappet cams. motors came out of a local boat that I purchased from the marina that was sitting for a few years. These motors had some exterior scaling which I cleaned of and painted. I put new water pump housings and impellers in bolted on a set of test headers and ran them on the hose. Both motors tested good with compression check . I did know the previous owner and the boat was barely used and was kept on a hoist and always flushed. These are complete less exhaust. $3800 each or $7400 for the pair

Tom 516-609-0499

as per the pm questions . The old owner claimed they were approx. 500hp.

casting number 10051107

7,000 for motors pick up this weekend

sent u a pm .

TTT
Nice blocks. To bad you weren't just selling the blocks. Those could make some nice 540's+.

http://www.s-series.org/htm/tech/GMP...ts/099-104.pdf

Do you know what heads are on it?
Thanks

did these sell

Deal pending.