Looking for (2) trim rams for #5 drives, pin dia. 7/8"

Anyone?

I think that's a 3/4 pin 7/8. The 5 should have a 1 inch as far as I was aware.

On eBay item # 222382191135 is a #5 actuator kit new in box, thought this might interest you?

#5 is 1" pins, if you are 7/8" either you don't have a #5 or gimbal ring is not for a #5.

Found them, thanks.

Yep. The #3 and #4 had 7/8 pins. The #5 had 1" pins. Lots of big shaft #4's being passed off as #5 drives.

If the pin that goes thru the drives case, is 7/8", you have a #4.

OK, will double check, thanks.

I still need these, turns out wrong PN on what I thought was the assy.

Anyone have a set that are in good working order? They are in fact for a #5 drive. 1" pin is correct.