Bravo Bulkhead Oil Fitting
10-18-2025 | 11:18 PM
#11
Thread Starter
VIP Member
Joined: Jun 2021
Posts: 3,531
Likes: 2,137
From: SW Ohio
That is a really nice piece. I follow Jarrod and A SHIP SHOW and sow these.
I just replaced mine with the OEM one. Not fun with engine installed.
I would like to buy one of these but I am unable to send you a private message because I just registered. Maybe you can send me one a private message if you have any left.
Thank you.
I just replaced mine with the OEM one. Not fun with engine installed.
I would like to buy one of these but I am unable to send you a private message because I just registered. Maybe you can send me one a private message if you have any left.
Thank you.
I do still have them. Just find a dead thread and spam it until you have your ten posts. Then send me a PM. We’ll exchange info.
Thanks. Brad.
02-02-2026 | 07:58 PM
#16
Thread Starter
VIP Member
Joined: Jun 2021
Posts: 3,531
Likes: 2,137
From: SW Ohio
Guys,
I just shipped two of these and thought I’d hit this thread up and see if there was any more interest. This is prime upgrade season. If anybody’s got their drive off, now is the time.
Thanks. Brad.
I just shipped two of these and thought I’d hit this thread up and see if there was any more interest. This is prime upgrade season. If anybody’s got their drive off, now is the time.
Thanks. Brad.
02-03-2026 | 10:02 AM
#17
Registered
Joined: Jun 2007
Posts: 7,322
Likes: 1,826
From: Merritt Island, FL
Motors are out, dry pipes are 6 weeks out.
02-07-2026 | 05:31 AM
#18
Registered
Joined: Feb 2026
Posts: 1
Likes: 0
MerCruiser Oil Reservoir Fitting Assembly
Do you have any made up and how soon would you be able to send one out? I'm up in northern Alberta Canada.
[email protected]
[email protected]
04-24-2026 | 01:13 PM
#19
Registered
Joined: Mar 2026
Posts: 11
Likes: 2
Great part! Perfect fit.
Giving this thread a bump because I am very impressed by the quality and the fit of this part. Brad obviously knows his craft. I just replaced both of the bulkhead fittings in my 2007 Chaparral 310 with Bravo III outdrives. It wasn't as bad as I had imagined getting in there with the engines in. And these new SS fittings slid right in! I'm glad I bit the bullet and replaced both. I'll never worry about them again.
Mercury engineers take notice! This is part you should be putting in.
Thanks Brad!
- Craig
Mercury engineers take notice! This is part you should be putting in.
Thanks Brad!
- Craig
Last edited by cmweber9; 04-24-2026 at 01:19 PM.
