LS project
#91
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
paint is Matrix
The following users liked this post:
Wildman_grafix (04-13-2023)
#92
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
New valve covers with 72mm bolt spacing allows to run the LS 3 style coils with no bracket
The following users liked this post:
dykstra (08-09-2023)
#93
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
The following 4 users liked this post by F-2 Speedy:
#94
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
Brother-in-law came in from TX and we went from this to this in two this in two a half days, all body panels aligned ( had to raise the cab and core support to match the bed lines PITA.... ) all the upper and lower holes drilled for the moldings........and a how bunch more.
Last edited by F-2 Speedy; 05-30-2023 at 02:32 PM.
#96
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
for sure, I like the all details of wiring and custom fab work
#97
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
I like how it sits, back spacing on the wheels made the stance perfect.....we drilled about 50 holes in this thing for the trim
Last edited by F-2 Speedy; 05-30-2023 at 06:24 PM.
The following 4 users liked this post by F-2 Speedy:
#98
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
not much going on but wiring, decided to move the pumps out of the cab and put them under the bed floor
The following users liked this post:
dykstra (08-09-2023)
#99
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
Fuel fill
The following users liked this post:
dykstra (08-09-2023)