LS project
#21
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
an additional 3 " C notch
The following users liked this post:
F-2 Speedy (07-05-2022)
#23
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
both sides done, full weld up next
#24
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
separated the cab, dissembling the frame and sending out for powder coat
The following 2 users liked this post by F-2 Speedy:
bencini231 (07-26-2022), dykstra (08-02-2022)
#25
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
headed to the powder coater Monday
#28
Registered
Not that you didn't notice but change that dipstick tube right now. It is a M Effer with the body on. Once they are rusted too bad they break off in the block. If it does that best way to remove is screw in a coarse thread screw in to it and get ready for a fight. Install is also pain in the ass. Not only the oring has to be seated but the metal ring a few mm above it need to be flush.
This is the one you have.
Chris
This is the one you have.
Chris
#29
Platinum Member
Platinum Member
Thread Starter
iTrader: (6)
I dont know what you're seeing ? theres no rust on the ds tube