Thanks Johnny I'm thinking the same thing so I'm mounting it on one side or the other using a actuator to scope it up and down in and out of the sponson it will be flush with the deck when in the down position most likely using a hatch deck lid so you will never see it.

Mr. Bob gave me a Engine's update. Got a little bling bling going on.

Hopefully those highly polished chrome valve covers will be easier to clean than my old polished aluminum ones were.

Surely we can get 75 MPH out of these. those Stellings headers in the background will look nice on here with the 5" cannons

Still chugging along with the Cat project. Gimbals are ready for epoxy primer and paint , and the engines are about 85% ready, then Bob can start on the boat once the engines are dynoed and the gimbals are together.

{NUYCE!!} It's an eastern shore word.

looking good KC

Thanks Ray hope your gang is all good.

Looks nice KC!

Thanks Jason, Taking a bare hull without one wire in it and turning it into a fast boat is a lot more work than I amagined but I have Bob O, my Allstate guy - In that deep voice, "I'm in good hands."

after seeing your last project the bar is set pretty high one this , looks like you are off to a heck of a start .

Yes there will be a bar...