41 Upgrades
#511
Hey guys, I tried to post 2 videos last night. Couldn't figure it out. When I click on the video icon, it says put in your u-tube video, I can't get it to post. Good day yesterday, had some delays, they had a hard time to get the computer to recognize the cd. They needed to set all the parameters in the ignition box before they can fire the motor. After a couple hours they got it. Motor turned 1/2 revolution and fired. Idled great, and throttle response was wicked. They put a little load on it,checked the timing, brought it up to temperature. Shut it down, let it cool over night. In the morning, going to torque everything, check valve lash, AND LET IT EAT..............
#512
Let me try this
https://www.offshoreonly.com/forums/004.mov
https://www.offshoreonly.com/forums/005.mov
No workie, so until someone explaines to my dumb ass, I wait
#516
Registered
Would you hurry up and tell us the numbers already, the suspense is killing me.
#517
Crazy Energy
Platinum Member
iTrader: (4)
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
Email me the video and ill put in in here. I have to do everything else in here might as well do that too. K.C.
[email protected]
Last edited by Velocity Vector; 06-30-2014 at 09:29 PM.
#520
Ok guys here is the scoop. I might have told ya's already, but I'll tell you again if I haven't My motor guys are father and son, father early 70s and son mid 40s. 2 months ago I requested they have the motors complete and dynod by May 30h. They told me that was doable. Well the father goes in for a knee replacement, that was 5 weeks ago. So, left the son doing everything. To dyno the motors they need the two of them. The son has been trying to get pop to come down for an hour to finish #1. Needless to say, son is frustrated almost as much as ME. This is the straight up reason the motors are not dynod yet. You can only imagine how FRUSTRATED I AM. Believe me when the results come I will post them. BOB