![]() |
Can you get to it by just pulling the drive only or do you have to remove the bell housing ? Answered my own question....yes, remove bell housing.
Drive is off...noticed the O ring that seals around the water inlet hose was pinched and ripped in half. Not a very good seal. Light corrosion, will have to clean up and work on getting the tool to try and remove bell housing so I can replace the water inlet hose. Seapump is on...what a PIA! My X DIMINSION is 3". Bottom of the boat is 3" below the center of the prop shaft. Dam it's hot! http://i44.photobucket.com/albums/f1...snlfv9wuf.jpeg |
I was able to break the hinge pins loose and separate the bell housing.
Amarket.com has an awesome website that talks about this issue (bravoitis) and provides step by step instructions. Here are the images from their web site. <iframe width="480" height="360" src="http://s44.photobucket.com/user/darobinson23322/embed/slideshow/"></iframe> |
Hey Ryan,i bought an 02 vr1 off kenny in the fall ,just bought a bblades 28 prop labbed to your recipe.Are you still finding that prop to be the best setup on your boat?I have the whipple tune on mine as well.
|
Originally Posted by Smith500
(Post 4534473)
Hey Ryan,i bought an 02 vr1 off kenny in the fall ,just bought a bblades 28 prop labbed to your recipe.Are you still finding that prop to be the best setup on your boat?I have the whipple tune on mine as well.
|
Originally Posted by Ryan00TJ
(Post 4336259)
Have Brett reference BB6452. That is my 28 lab recipe.
I have yet to send my prop to BBlades to modify to your specs/reference. I need some clarifications, was this reference applied to the supplied velocity Halls "labbed" prop that came with your VR! or was it applied to a "mercury" stock bravo1? I have both, the Halls velocity labbed bravo 1 and a stock bravo 1. I was thinking of applying the BB6452 to both. Thanks |
Originally Posted by modvp
(Post 4575224)
Ryan00TJ,
I have yet to send my prop to BBlades to modify to your specs/reference. I need some clarifications, was this reference applied to the supplied velocity Halls "labbed" prop that came with your VR! or was it applied to a "mercury" stock bravo1? I have both, the Halls velocity labbed bravo 1 and a stock bravo 1. I was thinking of applying the BB6452 to both. Thanks |
Originally Posted by Ryan00TJ
(Post 4575233)
Bblades used the above mentioned lab recipe on my original Velocity/Hall's labbed 28p Bravo one. Brett can answer whether or not to lab both. How different do they run now?
|
| All times are GMT -5. The time now is 07:37 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.