project hulls under 10k....
#17
Registered

Joined: Nov 2004
Posts: 922
Likes: 54
From: Lago Vista TX
I have a 1984 Corsa 26x7.... I'll copy and paste my sale ad below....




1984 Corsa 26'
Originally had a 350 with a Volvo drive.
NO Rot ! Transom replaced in 2015 to convert to Bravo. (18.5" X dimension)
Hook removed from hull and new bottom gelcoat in 2015 as well. (Couple scratches in it now tho')
The engine is a 454 mag. Mark IV block & gen v heads. Was a used short block i picked up. #7 had dropped a valve and messed up the piston. I honed it and installed a used piston. It rattles a little at idle but goes away over 1000 rpm.. runs good otherwise. Good oil pressure. Runs 64 mph with a full tank of fuel.
The used transom assembly I installed has a leak somewhere.. not sure where. The drive came off a cruiser. A little beat up from laying around the shop but oil is clean and works fine.
Has K planes mounted horizontal.. I had em mounted In Line with the hull but found it pushed the transom around too much for my liking so I moved them.
Gauges are used Gaffrig except the speedo . The speedo and the oil temp are not hooked up. Have the oil temp sensor just couldn't find a spot for it..
The interior has some staining and a few small nicks but overall in decent shape. Bolsters have been modified to be used as sit down seats. Could be put back tho' has a stereo with a CD changer and amp. Works, but nothing special.garmin GPS.. The engine hatch has been replaced by the previous owner and is now wood. Matches the curve of the deck looks ok, just not.original.
The trailer is a 1998 towmaster .. I did the bearings and installed MAXXIS tires is 2015. Has aluminum rims, new lights. Disc brakes but needs a new actuator.
Asking $6500.00. Fairly firm on the price...
Any questions, don't hesitate to call or message or text me.. 512-413-5621 or 512-584-9279
Located in Lago Vista tx
Originally had a 350 with a Volvo drive.
NO Rot ! Transom replaced in 2015 to convert to Bravo. (18.5" X dimension)
Hook removed from hull and new bottom gelcoat in 2015 as well. (Couple scratches in it now tho')
The engine is a 454 mag. Mark IV block & gen v heads. Was a used short block i picked up. #7 had dropped a valve and messed up the piston. I honed it and installed a used piston. It rattles a little at idle but goes away over 1000 rpm.. runs good otherwise. Good oil pressure. Runs 64 mph with a full tank of fuel.
The used transom assembly I installed has a leak somewhere.. not sure where. The drive came off a cruiser. A little beat up from laying around the shop but oil is clean and works fine.
Has K planes mounted horizontal.. I had em mounted In Line with the hull but found it pushed the transom around too much for my liking so I moved them.
Gauges are used Gaffrig except the speedo . The speedo and the oil temp are not hooked up. Have the oil temp sensor just couldn't find a spot for it..
The interior has some staining and a few small nicks but overall in decent shape. Bolsters have been modified to be used as sit down seats. Could be put back tho' has a stereo with a CD changer and amp. Works, but nothing special.garmin GPS.. The engine hatch has been replaced by the previous owner and is now wood. Matches the curve of the deck looks ok, just not.original.
The trailer is a 1998 towmaster .. I did the bearings and installed MAXXIS tires is 2015. Has aluminum rims, new lights. Disc brakes but needs a new actuator.
Asking $6500.00. Fairly firm on the price...
Any questions, don't hesitate to call or message or text me.. 512-413-5621 or 512-584-9279
Located in Lago Vista tx
Last edited by Boatally Insane; 04-28-2017 at 09:38 PM.
#18
Registered

Joined: Feb 2009
Posts: 8,356
Likes: 1,515
From: NW Michigan
78 spectra 32' check out 32 spectra deck mods and you see it her on OSO. Diffivult to explain what I did however the boat looks night and day difference. Comes on trailer. Excellent fought water boat. Basically drives, some interior. Comes with original. Etc trans also. Boat has a really neat look and a true 32. All wiring in place and bilge just polyurethane. Starboard rear stringer could use some work and same side transome however I have spent time repairing and both are very solid however to be a 100% someone might want to at least consider. Google search 78 or 79 32 spectra and hit images. I copied the chopped top to and is exactly like the blue and gray one among a couple others on the net.



