Anyone Know who makes these Thru Hull Water Pick-ups?
#1
Platinum Member
Platinum Member
Thread Starter
Anyone Know who makes these Thru Hull Water Pick-ups?
Looking for who makes these water pick-ups?
The part that goes thru the hull is 1.000 Diameter.
Then the threaded flange on the inside of the boat is for
1.000 pipe thread which is 1.250 dia. OD.
Thanks for any help
Cougarman
The part that goes thru the hull is 1.000 Diameter.
Then the threaded flange on the inside of the boat is for
1.000 pipe thread which is 1.250 dia. OD.
Thanks for any help
Cougarman
#8
Registered
Re: Anyone Know who makes these Thru Hull Water Pick-ups?
We don't normally make them that big. I am measuring the flange to make sure that the bolts will not hit the tube. More later.
#9
Platinum Member
Platinum Member
Thread Starter
Re: Anyone Know who makes these Thru Hull Water Pick-ups?
These are off my Cougar, they are mounted on 1.500" of plywood to stick through as far as they do in the photo's.
Thanks
Jon
Thanks
Jon
Thread
Thread Starter
Forum
Replies
Last Post
Maximus
General Boating Discussion
15
04-30-2004 06:29 PM