THRU-THE-HULL water pick-ups
#1
Registered
Thread Starter
Join Date: Oct 2000
Posts: 1,238
Likes: 0
Received 0 Likes
on
0 Posts
THRU-THE-HULL water pick-ups
When someone does a set of TTH Water pick-ups. The hose from the outdrive that used to bring the water to the sea strainer or sea water pump........that hose is cut and then attached to the TTH water pick-up. What happens to the hose on the outdrive end?
Last edited by enticer; 09-15-2002 at 03:22 PM.
#2
VIP Member
iTrader: (1)
There is a fitting on the outdrive housing inside the boat that must be removed and replaced with a block-off plate. I have that plate if you need it.
Email me at [email protected] and I will see how much I need for it. It has never been used and I'll cut you a sweet deal.
Dave
Email me at [email protected] and I will see how much I need for it. It has never been used and I'll cut you a sweet deal.
Dave
#3
Charter Member
Charter Member
Join Date: Oct 2000
Location: Central, Ohio USA
Posts: 1,074
Likes: 0
Received 0 Likes
on
0 Posts
You will need the plate on the inside as previously mentioned and you can cut the hose on the outside and just let the water run through the drive for cooling. I put a plug on the gimbal water inlet from the outside and drilled and tapped the side of my drive for a fitting and hose that I run to my billet drive cap.
Thread
Thread Starter
Forum
Replies
Last Post
cougarman
General Boating Discussion
8
12-05-2006 02:21 PM
Maximus
General Boating Discussion
15
04-30-2004 06:29 PM