Please post a pic. I will post mine up it suck to up and it's beat up pretty bad.

[ATTACH=CONFIG]522361[/ATTACH][ATTACH=CONFIG]522362[/ATTACH][ATTACH=CONFIG]522363[/ATTACH]Just a quick eye balling as a Mach up think I'm just going to vinyl it.. Another pic of the steps down so you can see thn a bit more clearly. An a bonus pic

Took the door out now need to figure out a plan for that. Mach'd up all the interior panels all resin up and test for. Material ordered and vinyl caps ordered. Just ordered more lights robreplacevtgevfactory cabin also. Put 2 of the 10 cockpit lighted in. Removed old cabin speakers and more dead wires from the boat.
Hope to mount VHF tomorrow run 3 antennas get all the rest of the lights amps and speakers pre wired and pull the flooring up. Flooring will be on order tomorrow. Foot rest will be flooring material instead of carpet easier to clean and blends better. Looking for a motor drop in by end of week

I built some really simple foot rests for mine a few years ago. It helped a lot.

These are pretty simple I'll get a pic of before and after of them. Just finished the rear seat lights and subs. Amp all mounted and wired in. Pulled the door out going to full powder coat a sheet of 16 stainless see how that goes. Rest of the fuel line hardware came in so I will be doing that. Ordered the indicator cables today along with the GPS antenna. Going to plumb the east of the boost gauges wire the lites to them and finish up the wiring mess to clean it all up. VHF will be mounted to day. I alrwady mounted the antenna and the am/fm antenna. Need water feed hoses in the gimbals before motors go in so waiting on that. Do shooting for next week on the motor drop in. Mounted the sea pumps lube bottles and brackets also fuel gauge senders and finished the oil hoses on the port motor. Used lokar dip sticks I put the other on in last night seems to do the trick.

I wish you well on the trim indicator adventure! I installed 2 new cables this weekend and one like 5 years ago using chase strings when pulling the old one's out and it's still a f&cking b!tch!

A bit easier with no motors in the boat. I will find out tomorrow when the cable shows up. Also going to do the water inlet hoses on gimbals I have one and just ordered the other. Once that is don't a motor goes in.

Most tedious job I've ever done was adding lights to the f2 boat, but using existing switches and making it look like it was there on day 1. Whoever wired those boats is an artist, and I wanted to kill him and his 7,000 zip ties lol

Yup I've already redone 150 I know this due to 3 packs if 50 wire ties down the tube so far and counting. But looks nice clean tight and done with pride

Very little done tonight, water intake hoses are done, drilled and tapped a broken trailer jack bolt, boost gauge port side hooked up. Removed the last remaing harness of extra wires. Trim cables will be in tomorrow, also I had a new stainless door cut out of 18 gauge instead of the 22 paper thin crap used befor. New door handle will be in on thrus day. Need to clean the bilge once again and drop port motor in.