36 37 Stepped Warrior
10-31-2014 | 05:28 AM
#251
Thread Starter
Brotherhood #1
Joined: Sep 2006
Posts: 12,026
Likes: 111
From: Swansea Mass
Doesn't cost me a ton at all. From working on boats I buy it by the big drum and burn the oil in a waste heater do no biggie to me. I change all oils every 5 hours. Oil is whole sale cost so no problem for peace of mind
12-12-2014 | 11:43 PM
#254
Registered
Joined: Jan 2006
Posts: 688
Likes: 0
From: wisconsin
[ATTACH=CONFIG]523534[/ATTACH][ATTACH=CONFIG]523535[/ATTACH]Ok 2nd motor is in. Hooked up water inlet, PS pump and cooler. Bouts gauge and water pressure set up. Main ground and connect between both motor ground hooked up. Tomorrow will be blower throttle shifter set up sea pump and lower blower pulley fuel lines.
12-24-2014 | 04:56 PM
#255
Thread Starter
Brotherhood #1
Joined: Sep 2006
Posts: 12,026
Likes: 111
From: Swansea Mass
not sure came with the motors when i got them. Im sure there out there and if not pretty simple to built them. There is a space plate i had milled out behind them to allow enough room for the bolt head not to hit the head? i believe
