272 shift cable
05-20-2002 | 07:57 PM
#1
Thread Starter
Charter Member #1171
Joined: Feb 2001
Posts: 4,018
Likes: 21
From: Clearwater, FL
272 shift cable
Put a kink in the housing changing the motor, now its a little stiff,,,,, has anyone changed theres yet,,, is it just the "33-C" I keep hearing about?
__________________
I want to live in a world where a chicken can cross the road and not have its motives questioned.
I want to live in a world where a chicken can cross the road and not have its motives questioned.
05-20-2002 | 10:10 PM
#2
Registered
Joined: Jan 2002
Posts: 4,612
Likes: 7
From: ALTO, MI
Are you talking about the short black one that goes to the outdrive? If so it isn't that fun to replace. pul the drive and pull out the complete old cable but make sure you tie a wire to the engine end so that you can pull in the new one. also when the new one is in make sure that it doesn't rub on the drive coupling on the back of the motor.
05-21-2002 | 09:32 AM
#3
Thread Starter
Charter Member #1171
Joined: Feb 2001
Posts: 4,018
Likes: 21
From: Clearwater, FL
NO,,, I got real lucky,,, it's the one from the shifter to the motor. I have heard of people paying almost $100 for one, I found a generic ( 33-C ) on www.rodnreel.com/dmarine/ for under $20,,, just a little skeptical.
__________________
I want to live in a world where a chicken can cross the road and not have its motives questioned.
I want to live in a world where a chicken can cross the road and not have its motives questioned.
Thread
Thread Starter
Forum
Replies
Last Post
DrFeelgood
Drives and Lower Units
5
11-05-2007 09:42 AM
