thank you
I tend to go a little to far with my projects... The bertram has taken a year and a half now. hope fully this one takes a lot less time...

thank you..

thanks
I don't think I can post photos. I pulled her to the yard today like 60mi it was raining like crazy the toung jack exploded on me, my friend and I had to lift her on to the hitch,, there was good air in the tires after pulling her out of the mud have some photos of the boat right after we pulled her out of the mud... but the good ones will be taken after tomarrow..

The Gladiator is a 36ft Cigarette which is a sit down boat, no cabin. I think OSD is refering to if you want to make have the controls in the middle of the boat between the two front seats but im not sure. This is how a Gladiator is setup. Alot of people have done their 20's set up like this. Good luck with the project!!

If you want some pictures for reference, send me your e-mail and I will send you some pictures of my bone-stock 20 Cigarette.

thanks I'd like that...

[email protected]

thank you
Larry

6 Pictures e-mailed.

tomuchstuff if you are looking for ideas on how to do your boat up one of the goys posted a ton of pictures you will need to go back 5 pages to air dog cig20 picture book its great .Also if you happen to get it done by next fall you may like to bring it to our nexted 20cig outing you can read up on that on page 6 good luck itis a graet boat and reminber you can never have to much power

That's a slick ride... what year is she? paint or gelcoat? are the hatch vents factory? are the tabs factory?


the engine hatch I have seems to have two round 6" holes that were filled, don't know how the hatch was cut for the scoop or if it even had one... And there were stainless 3 fin vents on each side of the engine room...

I pulled the boat apart today all but the gas tank pulled the floor that covers the tank so it will be out in the AM tomarrow.. she'll also get all her paint removed tomarrow then I can start undoing some damage...

Is this hull cored? I see the hatch and cockpit are foam cored..
can any one tell me the amount of letters and numbers in a cig HIN,, I think I found the hin,,,,,,

yes I need some ideas.. I have to try that...

Thank you....