Looking good Cassey. Hope to come down next yr and run my 38avs there and make a trip to bourbon st. Nice to see you taking my old boat to a new level. You'll have to post dyno sheets when you overhaul motors!

Thanks it's going slow. Almost have the little issue fixed and it will be back in full swing. Got the trans back from huber marine they are now 1150s with all the entra stuff you can do to them.

Looks like we are pulling the tanks on the boat ! The never ending project!

Man that sux. Spray in bed liner the floor panels while out looks great all back together.

Been busy. Tanks are out cleaned up so is that part of the boat ready to go back in with new foam.
Sanding more in the buildge so it's a mess again. [ATTACH=CONFIG]517049[/ATTACH]

Casey I want to pull my tanks do you have any more pictures of how they came out and how much glass you had to remove. thanks Keith

You have to cut the lip that hangs over the at the back bulk head. Mine was cut higher up then needed. But it was done that way to make sure nothing need addressing while it was getting work done. If you look at that First pic you can see it was cut up About 6" above the floor. Then remove the foam if it's even holding it in. They should come right up.

How are you ever going to get that thing done if you keep taking more chit out of it ha ha

thank you so much

ha ha I know I think I have crazy idea that I can make a 2014 out of 1988 its a 31' can of worms