lol hey it's got some trick crap done to it, would say it's now the strongest one ever built .Just lucky I don't have the molds! It would have been back in it. Lol

I'll tell you what that thing is built so much better then the last 3 scarabs I worked on I love the boat

Nice work Casey. You took on a huge project and it is looking good. Hang in there - it will all be worth it in the end.

Man what a project!! You are doing an Awesome job, keep up the good work! Can you post some more pictures and are you replacing or just cleaning the tanks?

There is a ton of work that will never be seen. The whole way the cockpit drains has been reworked to stop it from going by the tanks both front and rear bulk heads have been add too for strength. Had some stress cracks in the cabin door. Witch from some research is common? All that's been cut out and fix to never happen again. Etc

Tanks are good so keeping them.
[ATTACH=CONFIG]517058[/ATTACH]

[ATTACH=CONFIG]517059[/ATTACH]

You can see the over hang in these pictures that has to be cut out.

[ATTACH=CONFIG]517061[/ATTACH]
One of the tanks and you can see what was cut out but looking at the wire holes in the picture

[ATTACH=CONFIG]517074[/ATTACH]

They looked nasty but cleaned up very well.

[ATTACH=CONFIG]517310[/ATTACH]
Custom Transom plates hard anodized

You've gone this far you should just convert it over to bravos. Just a idea.

[ATTACH=CONFIG]517590[/ATTACH]
All holes filled getting closer to paint!


Like the way boats handle with trans's so Konrad PRS would be what I switched to.

Lighting jacks is doing a killer job on the glass work.
[ATTACH=CONFIG]517603[/ATTACH]
[ATTACH=CONFIG]517604[/ATTACH]