Inner Liner On 35 Cafe'

Reply Subscribe

Thread Tools

11-11-2004 | 01:47 PM

#11

GLH

Platinum Member

Joined: Dec 2002

Posts: 15,270

Likes: 21

From: Burlington, VT

Re: Inner Liner On 35 Cafe'

On mine it was a fresh water pump from the tank to the sink and cokpit shower Bob.

11-11-2004 | 01:51 PM

#12

DanB

Charter Member #71

Joined: Oct 2000

Posts: 924

Likes: 14

From: Phoenix, AZ

Re: Inner Liner On 35 Cafe'

The fresh water (sink) pump is under the floor of the port closet. I installed a seperate pump for my AC. Water for the AC needs to be drawn from the outside. Yours is prob that way too. Check under the cushions on the port side. Thats were I put mine.

11-11-2004 | 02:08 PM

#13

BOB ONEIL

Thread Starter

Charter Member # 1083

Joined: Feb 2001

Posts: 159

Likes: 0

From: BACK HOME AGAIN IN INDIANA

Re: Inner Liner On 35 Cafe'

Thanks guys, I'll check for another pump tonight. I just happen to see that one and thought I should figure out which one it was.

Still trying to figure everything out.

__________________
If it's not a thunder run.............than you're just burnen fuel!!!

11-12-2004 | 04:57 PM

#14

Cignificant

Charter Member

Joined: Oct 2000

Posts: 1,679

Likes: 1

From: Richmond, VA

Re: Inner Liner On 35 Cafe'

Quote:

Originally Posted by BOB ONEIL

Hey Steve,

I've got another question for ya. Is that access panel for the holding tank? Do you know where the fresh water tank is? Is it on the other side?

I've got the Perelli (sp) floor so I don't know what's under it.

Sorry for all the questions but, this boat is all new to me and I'm going to be doing a lot of remodeling this winter. Sounds like you've been there done that.

Thanks Bob

Yes, the access panel is to get to the waste tank/pump. My fresh water tank in on the port side - I can get to the top of it through an access panel in the bottom of the closet in the cabin.

I had my cockpit panels off the boat last winter to paint it. So I measured how much depth I had before ordering the speakers. The new speakers went into the holes that were already cut, tho' I did have to enlarge them.

Attached Thumbnails