XR ITS removal ?
#1
XR ITS removal ?
Would anybody be kind enuff to give me a typed out removal guide on a Bravo XR ITS. I am pulling both drives , transom assemblies , engines , ect.. also all steering including the helm. I know I will be removing in the order of drives , then engines , & then transom assemblies. But since this is a first for me on a bravo drive & the ITS transom I am not ashamed to ask for a good detailed map so I don't do anything stupid , or cause myself any extra work.
Also were would be the best place to break the hydralic lines ? Like I said I will be removing everything as far as steering goes incl. the helm.
I wish I had a good mec. manual for the ITS's but I don't , However I have faith in my OSO brothers to come through for me. I am sure it would help someone else here on the board in the future too. Thanks guys , Scott
Also were would be the best place to break the hydralic lines ? Like I said I will be removing everything as far as steering goes incl. the helm.
I wish I had a good mec. manual for the ITS's but I don't , However I have faith in my OSO brothers to come through for me. I am sure it would help someone else here on the board in the future too. Thanks guys , Scott
Last edited by littledcsrodshop; 07-09-2007 at 08:38 PM.
#3
Very similar to doing standard Bravo's. Disconnect, cap/plug engine power steering connections, disconnect electrical connections, throttle and shift cables, disconnect cap/plug fuel connections, remove exhaust hardware, pull engines. Disconnect, cap/plug the hydraulic connections at the ITS connection block mounted on the inner plate. Remove inner transom plate, remove ITS outer transom assembly.
Lot easier to talk about!
Lot easier to talk about!