Anchor Pin Play
03-27-2016 | 12:05 PM
#1
Thread Starter
Registered
Joined: May 2006
Posts: 281
Likes: 0
From: Covington, LA
Anchor Pin Play
After installing new transom assemblies everything is fairly snug but there's still a little in/out play due to wear in the rear anchor pin bore where the pin passes through the upper drive housing. What's the typical solution for this? Does someone make a bushing kit? I'm estimating the bore to be about .010 worn. Before i have oversized pins made was wondering if there was another route?
03-28-2016 | 09:56 AM
#2
Registered
Joined: Jun 2011
Posts: 2,169
Likes: 82
From: Henderson, KY
