Gauges installed and shifter in place...Rear vents later today...

[ATTACH=CONFIG]537953[/ATTACH]

[ATTACH=CONFIG]537954[/ATTACH]

[ATTACH=CONFIG]537955[/ATTACH]

Everything's in place and at the ready to bang this one out...
[ATTACH=CONFIG]540616[/ATTACH][ATTACH=CONFIG]540617[/ATTACH][ATTACH=CONFIG]540618[/ATTACH][ATTACH=CONFIG]540619[/ATTACH]

Moving along...putting motors in next week...
[ATTACH=CONFIG]540973[/ATTACH]

[ATTACH=CONFIG]540974[/ATTACH]

[ATTACH=CONFIG]540975[/ATTACH]

This thread was started 12/19/2014, here we are in May 2015. Getting real close to 5 months and not finished yet. Do all boats take this long to get built?

Normal "build cycle" is 13-16wks...some less, some more...lots of variables in play here.
There's been some work "behind the scenes" with respect to the custom motors, marine application conversion, trans work, etc.

UPDATE !!
Motor's are just about ready to install. Trans are back, externals mounted, etc.
[ATTACH=CONFIG]542492[/ATTACH]

Low water pickups in place and bottom detailed:
[ATTACH=CONFIG]542493[/ATTACH]

[ATTACH=CONFIG]542495[/ATTACH]

[ATTACH=CONFIG]542494[/ATTACH]

Shueman - Thanks for the name and number on the drive height question. going up another inch to a total of two above with the box.

looks damn good

Lots of chatter about this boat coming to the east coast ,stay tuned

Everything aligned to have it on the water by week's end ... !!