Glad to see you upgraded the steering! Looks great.

Btw if you decide you don't like the donkey dongs, "tip-sea" runs dry tails on his 36 outlaw and never gets bothered. They really aren't any louder than CMI's at idle. Moving they are sick

You may want to consider Drew Marine Shot Gun mufflers. Knowing how low the 32's sit reversion becomes a problem depending on how radical your cam is. My Big Tube Stellings are dry to the 5inch tip. It was loud enough to make my ears ring after 5 minuits of running. The shot gun mufflers do great against reversion while idling around the dock.

Moving the batterys forward (110 lbs), losing the silent choice and getting lighter engines( no EFI , water pumps ect ) I hope to raise up the rear boat. My emi are also dry to from the tip. I like to have both options with the downturns or just the flappers. I will water test it this week and then put the new interior in.

1st run today, onieda lake ny. 1ft chop. Easy 85 gps @ 4900 rpm with a stock 32 bravo. Good results. No leaks.

sitting higher???
how does it handle at 85?

Looking good Glen! I honked at you as you were about to get on the highway. I was doing some test and tuning on the new Hauler. Looks sharp

I saw you, BLUEMAGIC in the blue truck. My boat now has a very solid ride. Im impressed. I did not fully trim it out. I will wind it up when I feel more comfortable with it and post new pictures. I still need to finish installing the engine lid, pass seat and speakers . Rub rail was 4" above the water.

What HP?

I was told about 600HP. HP500- 741 cam. ported intake/heads. 9.5 cr. dry pipes. I was told 600hp. I think I''ll see 90gps.

Nice