some 32 questions
#11
Registered
Join Date: Jun 2011
Location: Thousand Islands area
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
I experimented with this with under the cooler I couldnt get it to work. Then mounted under back seat. Come to find out if your going to do the cooler your going to probably need a 0 Gauge ground wire think I was using a 4 or 6 and it wouldnt work. Needless to say in the middle of the project I wasnt going to take the time and money to go find some wire so it went under the seat.
You need like 2 ohms going to that ground or work.
You need like 2 ohms going to that ground or work.
#15
Registered
Join Date: Jun 2011
Location: Thousand Islands area
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
#18
The large thru hull is the sink drain. the other is for the bilge pump inside the cabin step.
The cooler just drains into the hull. Pizz poor design!
The cooler just drains into the hull. Pizz poor design!
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
#20
I don't think the cooler will fully drain if you do so. Maybe just enough that a sponge or towel will pick up. To close to call. I thought of doing so too when I 1st bought my boat.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.