The Truck is painted! Making progress towards...
#1
Charter Member #601
Charter Member
Thread Starter
The Truck is painted! Making progress towards...
I am making progress towards the boat motor. I painted the body on the new tow truck this weekend. It's an assembled 89 Blazer with 400" TPI motor. Should tow the boat quite well I am hoping.
I changed out my furnace heat exchanger today. For a 7yr old furnace that is too soon!! My Advice, dont buy a Janitrol furnace!! Stamped heat exchangers are no good. Next time tubular exchanger.
Tomorrow I am headed to Bay City to find a new place to live while working at my new job!
So things are happening, I may get to that cylinder head yet!! It would be a strange site to see me on the water in my own boat..
Today was a good day!! I hope it continues!
And I hope everyone else can enjoy some good luck for a change..
Dick
I changed out my furnace heat exchanger today. For a 7yr old furnace that is too soon!! My Advice, dont buy a Janitrol furnace!! Stamped heat exchangers are no good. Next time tubular exchanger.
Tomorrow I am headed to Bay City to find a new place to live while working at my new job!
So things are happening, I may get to that cylinder head yet!! It would be a strange site to see me on the water in my own boat..
Today was a good day!! I hope it continues!
And I hope everyone else can enjoy some good luck for a change..
Dick
#2
Neno the mind boggler
VIP Member
cool , ya gonna have some pics to post.an hows the TPI workin out.
__________________
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
#3
Charter Member #601
Charter Member
Thread Starter
Thanks Dave,
I am trying to get some pics....have to borrow my daughter's camera to take some.. I havent driven it yet to work out the EFI, but I am ready to!! Once I get the top on and the tailgate and some interior... one step at a time..
The paint was a big step, now it is a piece of cake!!
Dick
I am trying to get some pics....have to borrow my daughter's camera to take some.. I havent driven it yet to work out the EFI, but I am ready to!! Once I get the top on and the tailgate and some interior... one step at a time..
The paint was a big step, now it is a piece of cake!!
Dick
#4
VIP Member
Try using stainless steel heat exchangers. I run a dealership service dept and every few years I was replacing exchangers. I finally had enough and had some tests run that showed that the chemicals we use in the shop like brakeclean, carb clean, injection clnr all combined with the air and when burned at the burners were causing acid to prematurely rust out the exchangers. Now five years later the stainless ones are still like new!!
Glad to hear about the improving job scenario.Hope all is on the right track and you can splash your boat in 2002.
Take care
Glad to hear about the improving job scenario.Hope all is on the right track and you can splash your boat in 2002.
Take care
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Thread
Thread Starter
Forum
Replies
Last Post
Payton
General Boating Discussion
19
03-20-2004 12:35 PM