Whos using trannys with big power? over 1200 hp.
#11
Platinum Member
Platinum Member
We have had way better luck running our Bam Super Cyborg transmissions than we have with our Merc #6 Drysump drives.
So far 120 hrs and no transmission failures.
We have blown 3 new# 6 Drysumps to smithereens in the same time period.
The Bam Dry sump Cyborgs are rated up to 1300 ft lbs of torque
We run our 565Cis to 6500 rpms 14-71 high helix blowers @ 13 to 16 lbs of boost 1300 to 1400+ hp 1.24 ratio and Merc 36 P 17" cleavers
The new Bam's appear to be stronger than our drives
Good Luck!
So far 120 hrs and no transmission failures.
We have blown 3 new# 6 Drysumps to smithereens in the same time period.
The Bam Dry sump Cyborgs are rated up to 1300 ft lbs of torque
We run our 565Cis to 6500 rpms 14-71 high helix blowers @ 13 to 16 lbs of boost 1300 to 1400+ hp 1.24 ratio and Merc 36 P 17" cleavers
The new Bam's appear to be stronger than our drives
Good Luck!
#12
Registered
I know this, hell we all know this but you were taking claim to it a while back.
#14
Registered
I would look at converting your setup to the air shift crashbox. You have half the parts now. We know the crashbox will take your power and the dry clutch pack on the air shift is similar to top fuel race cars with far more power. I am like you and grew tired of losing a tranny. I went wtih crash boxes 2 years ago without a single issue of paint damage so far.
Thread
Thread Starter
Forum
Replies
Last Post
ratman
General Boating Discussion
7
03-06-2006 10:15 PM
Maximus
General Boating Discussion
27
03-20-2003 08:00 AM