New Borg Warner Transmission 2500 lbs torque
02-18-2009 | 12:55 AM
#11
Registered
Joined: Jan 2004
Posts: 2,777
Likes: 12
From: San Diego, California
Technology Marches ON!
Lookin at that unit based on the size relative to the input shaft size this thing looks physically pretty big and could be a possible space issue looking at that deep sump off the centerline of the shaft which might be a drive height problem in a lot of performance boats?? Would be awesome if it can take up to 2500ft/lbs in a light compact package that will fit the big horsepower performance boats!
Would be nice to have some dimension drawings and weight specs. Obviously that will come in time.
Best Regards,
Ray @ Raylar
Would be nice to have some dimension drawings and weight specs. Obviously that will come in time.
Best Regards,
Ray @ Raylar
02-18-2009 | 04:01 PM
#12
Thread Starter
Registered
Joined: Jun 2001
Posts: 2,303
Likes: 109
From: McHenry, Illinois
Other than being 1" longer the height should not be an issue in any driveline boat. I have BAM dry sumps now that are almost as deep. I still have at least 12 inches of room below the pan before it would hit the hull. Here is the Bam version compared the new trans.
Last edited by Brad Zastrow; 02-18-2009 at 04:04 PM.
Thread
Thread Starter
Forum
Replies
Last Post
NJgr8ful
General Boating Discussion
14
08-09-2007 11:02 AM
