Like Tree0Likes

Engine Install

Reply

Old 08-05-2010, 04:10 PM
  #1
Registered
Thread Starter
 
Join Date: May 2007
Location: Toronto Ontario
My Boat: 28 Pantera
Posts: 663
Default Engine Install

Does anyone have a diagram of how the engine bolts into the transom?

I just bought all of the proper hardware but have never done it before so I am trying to figure out the order. Probably should have paid closer attention when I pulled the motor but it has been nearly 6mnths.

It is an IMCO SC drive.

Any help is appreciated.
ar15meister is offline  
Reply With Quote
Old 08-05-2010, 04:13 PM
  #2
Registered
iTrader: (1)
 
Join Date: Jul 2003
Location: Michigan
My Boat: 36 SKATER, 38 POWERQUEST
Posts: 3,200
Default

Standard bravo application using the two vertical bolts?

From bottom up - nut, transom mount flange, spring w/fiber washer, bellhousing flange, spacer, washer, bolt.
fantastixvoyage is offline  
Reply With Quote
Old 08-05-2010, 04:15 PM
  #3
Registered
Thread Starter
 
Join Date: May 2007
Location: Toronto Ontario
My Boat: 28 Pantera
Posts: 663
Default

Originally Posted by fantastixvoyage View Post
Standard bravo application using the two vertical bolts?

From bottom up - nut, transom mount flange, spring w/fiber washer, bellhousing flange, spacer, washer, bolt.
it is 2 bolts and I believe yes a standard bravo style.
ar15meister is offline  
Reply With Quote
Old 08-06-2010, 07:12 AM
  #4
Gold Member
Gold Member
 
Dave M's Avatar
 
Join Date: Oct 2000
Location: LaPlata, MD, USA
My Boat: 2017 30 Concept, 300 Verados
Posts: 5,394
Default

Here's a diagram that might help

http://www.mercruiserparts.com/Show_...ND+SHIFT+CABLE
Dave M is offline  
Reply With Quote
Old 08-06-2010, 08:27 AM
  #5
Registered
 
Join Date: Jan 2007
Location: Mansfield, TX
My Boat: 1990 28 Apache SOLD!, 2005 Pioneer 175 Venture
Posts: 5,853
Default

Tape up the washers so they don't fall off when your setting the engine on the transom assembly.
TexomaPowerboater is offline  
Reply With Quote
Old 08-06-2010, 09:18 AM
  #6
Geronimo36
Gold Member
 
Panther's Avatar
 
Join Date: Sep 2002
Location: Elkton, MD
My Boat: 36' Apache Warrior / 22' Apache Scout
Posts: 11,902
Default

Originally Posted by TexomaPowerboater View Post
Tape up the washers so they don't fall off when your setting the engine on the transom assembly.
That or some 3M weatherstrip adhesive on the fiber washers helps.

However, I usually lower the engine into place and slide the spring washer and fiber washer under the bell housing.
Panther is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


OSO Sponsor
OSO Advertiser
OSO Advertiser
OSO Advertiser